Activity
 
chad.k
chad.k
Group: Registered
Joined: 2016/09/06
Eminent Member
2
@oregonerd For the scored rods, there were some early MK3 un...

In forum General discussion, announcements and releases

3 weeks ago
There are three parts from the MK3S+ that the MMU2S (for MK3...

In forum Hardware, firmware and software help

1 month ago
That's worse... If it's blowing that fuse, the power supply ...

In forum Hardware, firmware and software help

1 month ago
Which fuse is blowing? This page should give you an idea of ...

In forum Hardware, firmware and software help

1 month ago
Definitely lubricate your bearings. Not only does it keep t...

In forum General discussion, announcements and releases

1 month ago
The rubber is intended to seal the bearing from picking up d...

In forum Hardware, firmware and software help

1 month ago
I pulled them from the source code here:/p> The relevant lin...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
The firmware limits for the MK3S/S+ are 0 to 255 on X, -4 to...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Your X axis is running backwards. [0,0] should be on the fr...

In forum Hardware, firmware and software help

2 months ago
Z is often going to be the hardest to get perfect accuracy w...

In forum Hardware, firmware and software help

2 months ago
As long as you don't mind printing a full set, and adapting ...

In forum Hardware, firmware and software help

2 months ago
@lex Last time the motors needed to be swapped was the MK0/1...

In forum Hardware, firmware and software help

2 months ago
@joantabb You're right. My mistake.

In forum Hardware, firmware and software help

2 months ago
@3dprinterguy9134 I was having some similar problems after i...

In forum Assembly and first prints troubleshooting

2 months ago
I did the opposite with MK2.5-ish hardware in a MK3 frame, a...

In forum Hardware, firmware and software help

2 months ago
The best way I've seen to cleaning out a nozzle before repla...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Be careful when removing a nozzle: cracked heater block

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
That is actually a pretty good idea. Does anyone know what t...

In forum Others (Archive)

4 years ago
MK2 electronics enclosure for Mini Rambo 1.0a

In forum Improvements (Archive)

5 years ago
Share:

Please Login or Register