Notifications
Clear all
RedDawg
RedDawg
Group: Registered
Joined: 2018/01/07
Reputable Member
5
.... a pourable sealant of some sort? (Thompson's?) A pictur...

In forum General discussion, announcements and releases

2 days ago
..... that I use a filament "guide" (similar to the line "ey...

In forum General discussion, announcements and releases

5 days ago
.... to check: make sure the filament supply spool turns abs...

In forum General discussion, announcements and releases

5 days ago
The SD card slots/readers on both of my MK3s are flakey and ...

In forum General discussion, announcements and releases

6 days ago
.... didn't see you specified a MK3. The rest of my post is ...

In forum General discussion, announcements and releases

7 days ago
You didn't say which printer you have. I believe all of them...

In forum General discussion, announcements and releases

1 week ago
I didn't have any problems changing mine as well.

In forum General discussion, announcements and releases

1 week ago
Buy (a) Mini(s) and cut the Z axis down. Probably get it dow...

In forum General discussion, announcements and releases

2 weeks ago
Maybe a different extrusion? This shows parallel 20 x 45 ext...

In forum General discussion, announcements and releases

2 weeks ago
Why no mention of this on the Thingiverse website?

In forum General discussion, announcements and releases

2 weeks ago
Mind sharing the STL/3MF?

In forum General discussion, announcements and releases

2 weeks ago
I considered that approach also, but it complicates the desi...

In forum General discussion, announcements and releases

2 weeks ago
What are the specifications for these rails? Sources/vendors...

In forum General discussion, announcements and releases

2 weeks ago
What's more unsightly, seams or the one-piece support/remova...

In forum General discussion, announcements and releases

2 weeks ago
Invert 1st and 3rd pieces for printing, then stack glue them...

In forum General discussion, announcements and releases

2 weeks ago
I had not noticed that the inside edges of the groove were a...

In forum General discussion, announcements and releases

2 weeks ago
..... would be to cut it into three separate pieces, two fla...

In forum General discussion, announcements and releases

2 weeks ago
...... where IS the announcement likely to be made? Twitter?...

In forum General discussion, announcements and releases

4 weeks ago
Are you using the EXACT same .gcode file on both printers? T...

In forum General discussion, announcements and releases

1 month ago
I agree, this is irritating. Should be OPTIONAL in case you ...

In forum General discussion, announcements and releases

1 month ago
Page 1 / 14
Share: