Kevin Reid
Kevin Reid
Group: Registered
Joined: 2018/01/06
Trusted Member
3
In your test photo, the Z is way, way too high. The extrusio...

In forum General discussion, announcements and releases

1 month ago
If you had a MMU2 you could just specify zero purge volume f...

In forum General discussion, announcements and releases

1 month ago
Quick answer — you're correct. If the fan shroud is printed ...

In forum Hardware, firmware and software help

2 months ago
In PrusaSlicer (looking at my version 2.2.0+), right click o...

In forum General discussion, announcements and releases

2 months ago
The MMU2S gets power from the printer. It has two cables con...

In forum General discussion, announcements and releases

2 months ago
Underextrusion when printing faster suggests a clogged nozzl...

In forum How do I print this? (Printing help)

3 months ago
The surface texture all around looks much more irregular tha...

In forum General discussion, announcements and releases

4 months ago
The purge line is not a feature of the printer but just writ...

In forum General discussion, announcements and releases

4 months ago
To reduce the force of curling, you can try reducing heat lo...

In forum General discussion, announcements and releases

5 months ago
4 mm is really thick. For walls, two extrusion widths (0.8 m...

In forum General discussion, announcements and releases

5 months ago
If there's a problem with the filament sensor, I would expec...

In forum General discussion, announcements and releases

5 months ago
Could be a bad wire to the extruder. As Z moves up the angle...

In forum General discussion, announcements and releases

5 months ago
The black dot is probably a result of filament getting stuck...

In forum How do I print this? (Printing help)

7 months ago
Since flexible filament is squishier, it may not be pushing ...

In forum How do I print this? (Printing help)

7 months ago
Both too high and too low can result in messes. If the nozzl...

In forum Assembly and first prints troubleshooting

7 months ago
It looks like your Z is far too high. A first layer should n...

In forum Assembly and first prints troubleshooting

7 months ago
Yes, the SD card is only used for print files. You can use a...

In forum General discussion, announcements and releases

7 months ago
I haven't printed MMU2S parts, but all of the MK3/S printer ...

In forum General discussion, announcements and releases

8 months ago
For adhesion on the textured sheet, try setting your Live Z ...

In forum General discussion, announcements and releases

9 months ago
For PETG, get and use the powder-coated (textured) sheet. Th...

In forum General discussion, announcements and releases

9 months ago
Page 1 / 4
Share:

Please Login or Register