Peter M
Peter M
Group: Registered
Joined: 2018/01/02
Prominent Member
2
Only clean with dish soap, if you use a lot of hot water, mo...

In forum Assembly and first prints troubleshooting

2 days ago
Clean bed with dish soap and nothing else. Use a lot of hot ...

In forum Assembly and first prints troubleshooting

2 days ago
Clean bed with dish soap only, nothing else is needed. Then ...

In forum General discussion, announcements and releases

2 days ago
Wen my first layer does not work I do this: The problem with...

In forum General discussion, announcements and releases

2 days ago
Try to print with higher extruder temp. Try print slower. Ar...

In forum Assembly and first prints troubleshooting

4 days ago
First layer looks good. Does the print work now?

In forum Assembly and first prints troubleshooting

4 days ago
You could have a partial clog. Move extruder to high positio...

In forum Assembly and first prints troubleshooting

4 days ago
Extra and normally not needed: print first layer slower, Bed...

In forum Hardware, firmware and software help

6 days ago
Elephants foot option, if you use a brim attach to model , d...

In forum Hardware, firmware and software help

6 days ago
Try to go a little bit lower. Pei sheet and powder coated sh...

In forum Hardware, firmware and software help

1 week ago
Wen printing petg, watch for blobs on the print, I do then l...

In forum Assembly and first prints troubleshooting

1 week ago
Is it not the model you are using? try with a good stl file....

In forum Assembly and first prints troubleshooting

1 week ago
Extra and normally not needed, first layer extruder hotter, ...

In forum Assembly and first prints troubleshooting

1 week ago
Only clean with dish soap, alcohol is not needed after clean...

In forum Assembly and first prints troubleshooting

1 week ago
A big print is normally not a problem, but you could try to ...

In forum How do I print this? (Printing help)

2 weeks ago
What bed you are using? Pei or powder coated bed? What filam...

In forum How do I print this? (Printing help)

2 weeks ago
On prusa website there should be a manual on how to do this.

In forum Hardware, firmware and software help

2 weeks ago
Window cleaner will leave a residue behind , and pla will st...

In forum Assembly and first prints troubleshooting

2 weeks ago
Search youtube for a movie on first layer calibration, searc...

In forum Assembly and first prints troubleshooting

2 weeks ago
Your first layer is to high. Wen you start a print, wen the...

In forum Assembly and first prints troubleshooting

2 weeks ago
Page 1 / 45
Share:

Please Login or Register