Notifications
Clear all
bobstro
bobstro
Group: Registered
Joined: 2017/12/31
Illustrious Member
The upcoming release of PrusaSlicer 2.4 includes options for...

In forum PrusaSlicer

2 days ago
It moves the bed fully forward. Line 12 sets the printer to ...

In forum General discussion, announcements and releases

2 days ago
Bridging such short distances is not normally a problem on t...

In forum Hardware, firmware and software help

2 days ago
I've got a documented end gcode example here. Lines 12 and 1...

In forum General discussion, announcements and releases

2 days ago
There is a rather long thread on this topic herethat might b...

In forum Hardware, firmware and software help

3 days ago
The video @sylviatrilling pointed you to shows one method of...

In forum How do I print this? (Printing help)

3 days ago
By looking at the 3MF, we can both examine the part to see i...

In forum How do I print this? (Printing help)

4 days ago
There is certainly support for prints on the Mk3, but there ...

In forum General discussion, announcements and releases

4 days ago
Here's what I'm seeing today: The login button has always di...

In forum General discussion, announcements and releases

4 days ago
The factory presets will work well enough for most people in...

In forum How do I print this? (Printing help)

4 days ago
Oh gosh no. Lots of folks here smarter on 3D printing than I...

In forum General discussion, announcements and releases

4 days ago
I'm hoping it's either a Halloween theme attempt or somebody...

In forum General discussion, announcements and releases

4 days ago
I believe -- perhaps incorrectly based on older information ...

In forum Hardware, firmware and software help

4 days ago
Absolutely. If you're getting a bit of over extrusion, it ca...

In forum How do I print this? (Printing help)

4 days ago
Lost my 1st post apparently. Sorry if this is a repost. Unfo...

In forum General discussion, announcements and releases

5 days ago
Nothing other than experience. I'm no pundit, but I've been ...

In forum General discussion, announcements and releases

5 days ago
I've made a point of using a unique email alias and a comple...

In forum General discussion, announcements and releases

5 days ago
I only had success with Colorfab XT-CF20 when I reduced Maxi...

In forum How do I print this? (Printing help)

6 days ago
It's an old security measure. Just archive (zip) up any atta...

In forum General discussion, announcements and releases

6 days ago
I know it doesn't suit everybody, but I absolutely would pre...

In forum General discussion, announcements and releases

6 days ago
Page 1 / 414
Share: