Notifications
Clear all
cyrille.p
cyrille.p
Group: Registered
Joined: 2016/08/30
Estimable Member
4
Very very good ! 😆 I love it !! By the way, I'm now pr...

In forum Assembly and first prints troubleshooting

3 years ago
And even some personalized ABS pens:

In forum Hardware, firmware and software help

3 years ago
Here a some successful prints: The penguin: ...

In forum Hardware, firmware and software help

3 years ago
I just want to confirm what eric experienced. I installed my...

In forum Hardware, firmware and software help

3 years ago
For the moment (and in the waiting of an update), I put a 1....

In forum General discussion, announcements and releases

3 years ago
Just mark selector position after homing, install firmware v...

In forum General discussion, announcements and releases

3 years ago
I used your parameters and my filament tip still measure mor...

In forum Assembly and first prints troubleshooting

3 years ago
I think this PTFE tube with 2.5mm id is the way to go for me...

In forum General discussion, announcements and releases

3 years ago
MMU1 hotend for MMU2

In forum Hardware, firmware and software help

3 years ago
I used your parameters and my filament tip still measure mor...

In forum Assembly and first prints troubleshooting

3 years ago
Thank you for your reply flaviu. I'm using PLA prusament (b...

In forum Assembly and first prints troubleshooting

3 years ago
Hi all, I've been trying to get at least one succesful print...

In forum Assembly and first prints troubleshooting

3 years ago
Hello, I've got a mk2.5 + MMU2 since 1week now, and I'm t...

In forum General discussion, announcements and releases

3 years ago
Merci pour ta réponse LaPointe 1) Bonne idée le reset, je n...

In forum Dépannage pour l'assemblage et les premières impressions

3 years ago
Problèmes depuis l'upgrade vers mk2.5

In forum Dépannage pour l'assemblage et les premières impressions

3 years ago
Bonjour, Je voulais juste anticiper le moment où mon extrude...

In forum Aide concernant le matériel, le firmware ou un logiciel

3 years ago
Extrudeur du MMU compatible MK2 seul (sans le MMU) ?

In forum Aide concernant le matériel, le firmware ou un logiciel

3 years ago
I’d be interested to see your Gcode for the haunches and hea...

In forum Awesome prints (Hall Of Fame)

4 years ago
😎

In forum Awesome prints (Hall Of Fame)

4 years ago
Thank you georg.s2, I appreciate your kind words. I used fus...

In forum Awesome prints (Hall Of Fame)

4 years ago
Page 1 / 8
Share: