Notifications
Clear all
tdub415
tdub415
Group: Registered
Joined: 2017/12/24
Eminent Member
2
Thermistor Increasing Temp

In forum Hardware, firmware and software help

2 years ago
That was indeed exactly my issue. I had absolutely used a t...

In forum Hardware, firmware and software help

2 years ago
I definitely swapped the tube when I upgraded the exturder (...

In forum Hardware, firmware and software help

2 years ago
I'm 99.9% sure that I used one of the 2 1.85mm inner diamter...

In forum Hardware, firmware and software help

2 years ago
Filament Head Diameter

In forum Hardware, firmware and software help

2 years ago
Having to be there to cut the end of a spool kinda defeats t...

In forum Hardware, firmware and software help

2 years ago
Spool Join Run Out Not retracting

In forum Hardware, firmware and software help

2 years ago
Color Print Partially Working

In forum Hardware, firmware and software help

3 years ago
My MMU2.0 arrived but I have not had time to assmeble and st...

In forum General discussion, announcements and releases

3 years ago
I've tried atomic pulling, and they seemed to come out clean...

In forum Hardware, firmware and software help

3 years ago
I happened to clip the filament just at/above the gear notch...

In forum Hardware, firmware and software help

3 years ago
I've tried atomic pulling, and they seemed to come out clean...

In forum Hardware, firmware and software help

3 years ago
Extruder clicking and jamming after nearly every good print

In forum Hardware, firmware and software help

3 years ago
What camera setup are you using for time-lapses? I'm lookin...

In forum Awesome prints (Hall Of Fame)

3 years ago
CA (super) glue has worked great for me, though I'd recommen...

In forum General discussion, announcements and releases

3 years ago
I'll change from working great, to working some of the time....

In forum Improvements (Archive)

3 years ago
I'm using 1.3.7rc2 and it's working great with the MK3. I s...

In forum Improvements (Archive)

3 years ago
Strange Extruder noise

In forum Others (Archive)

3 years ago
1) Octoprint doesn't seem to register that the printer has s...

In forum General discussion, announcements and releases

3 years ago
I actually saw that last night when I saw there was a notifi...

In forum General discussion, announcements and releases

3 years ago
Page 1 / 2
Share: