Notifications
Clear all
jonathon.b
jonathon.b
Group: Registered
Joined: 2017/12/20
Estimable Member
4
The way I do it is.... Remove the orange tube, insert filam...

In forum Hardware, firmware and software help

3 years ago
I've got a quick hack to improve the spool holders, if you h...

In forum General discussion, announcements and releases

3 years ago
Finished pictures

In forum General discussion, announcements and releases

3 years ago
First few days and prints

In forum General discussion, announcements and releases

3 years ago
It’s sorted now, use the latest version of slic3r and it sho...

In forum Print tips (Archive)

3 years ago
> Has anyone (who speaks German) tried contacting one of ...

In forum General discussion, announcements and releases

4 years ago
I've followed the instructions in the manual to remove the n...

In forum Hardware, firmware and software help

4 years ago
You'd think Prusa would be more active (or at least communic...

In forum General discussion, announcements and releases

4 years ago
Would you mind sharing the model? The indents seem to help s...

In forum General discussion, announcements and releases

4 years ago
I’m guessing it’s done on S3D, it’s a good little test. So ...

In forum General discussion, announcements and releases

4 years ago
Posted this on the 602 github but thought may as well post i...

In forum General discussion, announcements and releases

4 years ago
Most people are here: That said, beware of the negative pe...

In forum General discussion, announcements and releases

4 years ago
Well on the FB groups I have seen pictures with verry nice i...

In forum General discussion, announcements and releases

4 years ago
I made this post in another subforum, when printing 2 perime...

In forum General discussion, announcements and releases

4 years ago
It has been a bit quiet, and theres is still is no improveme...

In forum General discussion, announcements and releases

4 years ago
It has been a bit quiet, and theres is still is no improveme...

In forum General discussion, announcements and releases

4 years ago
Inconsistent extrusion per layer. (Eg, some layers look thic...

In forum General discussion, announcements and releases

4 years ago
Do you know if they have the same probelms were seeing? I ...

In forum Hardware, firmware and software help

4 years ago
Do you know if they have the same probelms were seeing?

In forum Hardware, firmware and software help

4 years ago
Per this thread: I noticed that the extrusion inconsistency...

In forum General discussion, announcements and releases

4 years ago
Page 1 / 9
Share: