Notifications
Clear all
LittleNeutrino
LittleNeutrino
Group: PrusaLink-beta
Joined: 2017/12/18
@steve-4 How did you get the TPU in there? I tried to load T...

In forum General discussion, announcements and releases

2 years ago
So I used those settings, and it will print the first couple...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
@strankler 4.0.3 is NOT released, the Candidate is out, howe...

In forum General discussion, announcements and releases

2 years ago
@strankler can you post over on the Octoprint thread, what y...

In forum General discussion, announcements and releases

2 years ago
@texy The LAN port is on the Printer, the WLAN (Wireless) is...

In forum General discussion, announcements and releases

2 years ago
@texy Sadly it disabled the DHCP for the LAN port (its a rep...

In forum General discussion, announcements and releases

2 years ago
@texy Keep in mind folks this is a RC and its buggy.

In forum General discussion, announcements and releases

2 years ago
@olef Yeah I noticed the LAN port too, technically its not d...

In forum General discussion, announcements and releases

2 years ago
Anyone that has it working, can they post a dump of the Prin...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
@charles-hart85 My primary reason for buying the mini was th...

In forum General discussion, announcements and releases

2 years ago
So far so good, I have managed to print about 20 different t...

In forum General discussion, announcements and releases

2 years ago
ok, i switched to a different pi and now its working without...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
@fns720 I just tried this, no dice, and its the same USB cab...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
OK, printer is put together, flashing now. There were a few...

In forum General discussion, announcements and releases

2 years ago
@matteo-cristini My vote is Free Spools of Prusament for the...

In forum General discussion, announcements and releases

2 years ago
Mine is out for Delivery right now so it should be there by ...

In forum General discussion, announcements and releases

2 years ago
@burtronix I understand that I was looking for the STL file.

In forum General discussion, announcements and releases

2 years ago
@frankincell What is the Rocci Model?

In forum General discussion, announcements and releases

2 years ago
Mine will have the PEI sheet however I do have a Textured on...

In forum General discussion, announcements and releases

2 years ago
I would say it comes down to what you plan to do with the pr...

In forum General discussion, announcements and releases

2 years ago
Page 2 / 5
Share: