Activity
 
Notifications
Clear all
Dave J
Dave J
Group: Registered
Joined: 2017/12/10
Trusted Member
3
@herbert-1, @craigmonroe6 Put your files into a ZIP file and...

In forum General discussion, announcements and releases

1 year ago
Are you printing in a slightly dusty environment? Check if y...

In forum General discussion, announcements and releases

2 years ago
Try it and see what happens! Personally, I haven't had any p...

In forum General discussion, announcements and releases

2 years ago
Have you tried printing something completely different, and ...

In forum Assembly and first prints troubleshooting

2 years ago
@mssj I remove (or rather disconnected) my MMU2S because I a...

In forum General discussion, announcements and releases

2 years ago
Your print failure probably caused the Pinda sensor to be mo...

In forum General discussion, announcements and releases

2 years ago
There are step by step instructions at heat bed thermistor r...

In forum General discussion, announcements and releases

2 years ago
It is not a PrusaSlicer setting. The printer filament sensor...

In forum Assembly and first prints troubleshooting

2 years ago
@jeffrey-j7, can you not find the short or broken cable and ...

In forum General discussion, announcements and releases

2 years ago
Try cleaning the selector rods and copper tubes. Do NOT oil/...

In forum General discussion, announcements and releases

2 years ago
If you have a MK3S, then continue as usual, the printer will...

In forum Coronavirus (COVID-19)

2 years ago
No, it will act just like a MK3S (almost), except that you w...

In forum General discussion, announcements and releases

2 years ago
Try increasing the bed temperature, take it up by 5 degC to...

In forum General discussion, announcements and releases

2 years ago
I know what you are saying, but carriage is based on weight ...

In forum General discussion, announcements and releases

2 years ago
You could check to see if a product revision request has bee...

In forum General discussion, announcements and releases

2 years ago
If PLA is warping, you may want to try increasing the bed te...

In forum General discussion, announcements and releases

2 years ago
I have never used a glue stick, sorry.

In forum Coronavirus (COVID-19)

2 years ago
The part of the bed which you have not used before may need ...

In forum Coronavirus (COVID-19)

2 years ago
If you are printing the same item repeatedly, like the RC3 s...

In forum Hardware, firmware and software help

2 years ago
This suggests that the end of the filament is kinked, or the...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 5
Share: