xhillb61
xhillb61
Group: Registered
Joined: 2017/12/03
Trusted Member
3
As it happens, my brother is Co-Autor in this study. I talke...

In forum Coronavirus (COVID-19)

4 months ago
I think your nozzle is too close to the bed. I would suggest...

In forum Assembly and first prints troubleshooting

4 months ago
I have a MK3 and two Minis. I was also wondering if there wa...

In forum Hardware, firmware and software help

9 months ago
I also mostly use the cheapest filament I can get my hands o...

In forum General discussion, announcements and releases

11 months ago
You should also take in account that water solvable Filament...

In forum General discussion, announcements and releases

12 months ago
Turn off the printer, insert the stick, start the printer. I...

In forum Hardware, firmware and software help

12 months ago
That is awesome!!!!

In forum Awesome prints (Hall Of Fame)

12 months ago
No, it´s correct this way

In forum General discussion, announcements and releases

12 months ago
RE: Not Confident in the purchase of a Mini ..... cancel?

In forum General discussion, announcements and releases

1 year ago
Used Cura probably less than 10 times before. It took me 5 m...

In forum General discussion, announcements and releases

1 year ago
My take on this problem: on my first Mini the Minda wasn´t f...

In forum Assembly and first prints troubleshooting

1 year ago
Let me ask you guys a question: why, if you guys are right, ...

In forum General discussion, announcements and releases

1 year ago
Let me ask you guys a question: why, if you guys are right, ...

In forum General discussion, announcements and releases

1 year ago
Let me ask you guys a question: why, if you guys are right, ...

In forum General discussion, announcements and releases

1 year ago
PETG likes the Z a little bit higher. So if you printing PLA...

In forum General discussion, announcements and releases

1 year ago
@tom-6 Already got my 2nd, I´m still here, it´s quite entert...

In forum General discussion, announcements and releases

1 year ago
Rick, on my experience it´s allways al small issue causing p...

In forum General discussion, announcements and releases

1 year ago
So I got my second Mini a week ago, neither my 1. Mini (deli...

In forum General discussion, announcements and releases

1 year ago
Looks like a clogged nozzle

In forum Assembly and first prints troubleshooting

1 year ago
Giving the PEI sheet an acetone treatment before printing PE...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 3
Share:

Please Login or Register