sean.h8
sean.h8
Group: Registered
Joined: 2017/12/01
Honorable Member
1
No, with a 6 inch long filament extruder for making your own...

In forum Hardware, firmware and software help

3 years ago
With the volcano, and the upcoming MegaVolcano, you can prin...

In forum Hardware, firmware and software help

3 years ago
"It's 100% useless, and does not fix this problem." "This 1...

In forum General discussion, announcements and releases

3 years ago
Cube on right has hacked gcode. I'm going to assume you've ...

In forum General discussion, announcements and releases

3 years ago
THIS JUST IN Image with light from above. Image with l...

In forum General discussion, announcements and releases

3 years ago
Solved mine. Others haven't had so much luck. So replacing t...

In forum General discussion, announcements and releases

3 years ago
This issue was resolved. When the printer restarts it loads...

In forum General discussion, announcements and releases

3 years ago
I agree with Joan, your issue with your first layer is your ...

In forum Hardware, firmware and software help

3 years ago
What did you replace your heatbreak with? The same part, or...

In forum General discussion, announcements and releases

3 years ago
Pending other suggestions, I've ordered a replacement nozzle...

In forum Hardware, firmware and software help

3 years ago
if you are printing at 270 then you should really think abou...

In forum Hardware, firmware and software help

3 years ago
270 and 265 are way too hot for abs. 230-250 is really where...

In forum Hardware, firmware and software help

3 years ago
Your printer came with an injection molded part? I think we...

In forum Hardware, firmware and software help

3 years ago
PJR - Some colors it's VERY hard to see the effect. You need...

In forum General discussion, announcements and releases

3 years ago
***** I am unsure if I have asked you this, but does the t...

In forum Hardware, firmware and software help

3 years ago
Hey Sean, Any chance of you printing another single wall cu...

In forum Hardware, firmware and software help

3 years ago
check the heater wiring to ensure no short circuits I thin...

In forum General discussion, announcements and releases

3 years ago
Keep an eye on it, and watch the temps. Is the hot-end temp ...

In forum Hardware, firmware and software help

3 years ago
Thanks! Hm... I guess the information I'm really looking for...

In forum Hardware, firmware and software help

3 years ago
But still i only have problem with the supplied Prusa silver...

In forum Hardware, firmware and software help

3 years ago
Page 1 / 29
Share:

Please Login or Register