Notifications
Clear all
Mitchimal
Mitchimal
Group: Registered
Joined: 2021/11/23
Active Member
1
Ok, so it's just started happening again and I think it is t...

In forum Hardware, firmware and software help

2 days ago
Also in both videos, it's passed the initial exposure stage ...

In forum Hardware, firmware and software help

4 days ago
I don't see why exposure settings have anything to do with t...

In forum Hardware, firmware and software help

4 days ago
I don't see why exposure settings have anything to do with t...

In forum Hardware, firmware and software help

4 days ago
Ahhh that's very interesting and also sounds logical. I'm pr...

In forum Hardware, firmware and software help

4 days ago
Also and I'm not sure if this is related, when I home the tr...

In forum Hardware, firmware and software help

6 days ago
I have a very similar issue. Thought I posted about it yeste...

In forum Hardware, firmware and software help

6 days ago
There have been a few variations to the design since I start...

In forum How do I print this? (Printing help)

6 days ago
Sorry, see attached Body1

In forum How do I print this? (Printing help)

1 week ago
Did anyone find a solution for this? I was thinking, does he...

In forum Assembly and first prints troubleshooting

1 week ago
Tilt tray making bang noise and not going down

In forum Assembly and first prints troubleshooting

1 week ago
Did you resolve this? Not sure if it's the same thing I'm ge...

In forum Assembly and first prints troubleshooting

1 week ago
Ring w SLOTS

In forum How do I print this? (Printing help)

1 week ago
Hey Diem, Thanks for the reply. Everything is default at the...

In forum How do I print this? (Printing help)

1 week ago
Prusaslicer manual supports not touching part

In forum How do I print this? (Printing help)

1 week ago
Share: