Activity
 
Notifications
Clear all
Dr_GN
Dr_GN
Group: Registered
Joined: 2017/11/26
Eminent Member
2
Thanks both. Yes, I think if this kind of thing happens agai...

In forum Hardware, firmware and software help

11 months ago
The first 8 hour print was perfect, and the first of the rem...

In forum Hardware, firmware and software help

11 months ago
I fitted the new thermistor, updated the firmware and ran th...

In forum Hardware, firmware and software help

12 months ago
@milos-v Sorry I was thinking of the heating element, not th...

In forum Hardware, firmware and software help

12 months ago
@milos-v No problem! I did try testing at the wires next to ...

In forum Hardware, firmware and software help

12 months ago
Ok so I poked the meter wires into the plug - open circuit, ...

In forum Hardware, firmware and software help

12 months ago
@milos-v Ok so I just checked the fuses - all OK. Checked al...

In forum Hardware, firmware and software help

12 months ago
Just for completeness - I ran a 16 hour job yesterday, overn...

In forum Hardware, firmware and software help

12 months ago
And also just to say, when I switch the machine on, the serv...

In forum Hardware, firmware and software help

12 months ago
@milos-v Yes, also, when it failed, it didn't fail and retur...

In forum Hardware, firmware and software help

12 months ago
@joantabb Thanks Joan. Actually, something's wrong there - Y...

In forum Hardware, firmware and software help

12 months ago
@karl-herbert Thank you. Based on that, and Milos's tests, I...

In forum Hardware, firmware and software help

12 months ago
Ok so I measured with the sensor in my hands - about 70 K Oh...

In forum Hardware, firmware and software help

12 months ago
SORRY! I made a mistake with a plug! The ambients (nominals)...

In forum Hardware, firmware and software help

12 months ago
@milos-v And yes, I disconnected and measured from the pins.

In forum Hardware, firmware and software help

12 months ago
@milos-v Thanks, The bed nominal temperature is high (28 deg...

In forum Hardware, firmware and software help

12 months ago
The thermistor came out of the head quite easily - the grubs...

In forum Hardware, firmware and software help

12 months ago
I just checked both thermistors (bed and nozzle, and they bo...

In forum Hardware, firmware and software help

12 months ago
Thanks Milos.

In forum Hardware, firmware and software help

12 months ago
The strange thing is, according to the Prusa info: "Thermal ...

In forum Hardware, firmware and software help

12 months ago
Page 1 / 2
Share: