Activity
 
Notifications
Clear all
Nathan
Nathan
Group: Registered
Joined: 2016/07/28
Trusted Member
3
I have been using it for many months and have had 0 problems...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
As far as I can tell everything is aligned properly, but I w...

In forum General discussion, announcements and releases

4 years ago
The belt is constantly rubbing , I have about 50 hours of pr...

In forum General discussion, announcements and releases

4 years ago
New Parts, X Belt Still Rubbing

In forum General discussion, announcements and releases

4 years ago
I have also been getting worse quality out of my MK3 compare...

In forum Others (Archive)

4 years ago
I actually use a cable chain for the main wire bundle at the...

In forum Others (Archive)

4 years ago
I actually use a cable chain for the main wire bundle at the...

In forum Others (Archive)

4 years ago
I actually use a cable chain for the main wire bundle at the...

In forum Others (Archive)

4 years ago
Which R2 Parts are Needed

In forum Others (Archive)

4 years ago
Stay up to date on Slic3r Profiles

In forum Others (Archive)

4 years ago
Just wanted to add another name to the list of failed power ...

In forum Hardware, firmware and software help

4 years ago
If you were going to reprint the x axis parts right now woul...

In forum General discussion, announcements and releases

4 years ago
I have also been having shifting problems with the 150 firmw...

In forum Others (Archive)

4 years ago
The message was something like "Failed to detect bed point, ...

In forum Others (Archive)

4 years ago
It would fail during the 9 point level it does before each p...

In forum Others (Archive)

4 years ago
Large Z Offset

In forum Others (Archive)

4 years ago
I ended up having to replace the entire heatblock + thermist...

In forum Others (Archive)

4 years ago
Using and Existing Raspberry Pi 3

In forum Others (Archive)

4 years ago
Wild Hotend Temp. Swings

In forum Others (Archive)

4 years ago
I will take a look at that tonight, didn't get a chance to m...

In forum Others (Archive)

4 years ago
Page 1 / 3
Share: