Notifications
Clear all
john.n13
john.n13
Group: Registered
Joined: 2017/11/20
Estimable Member
4
but each filament has a temperature settings Really? Wher...

In forum Others (Archive)

3 years ago
Import duties are not always collected, but they are always ...

In forum General discussion, announcements and releases

3 years ago
Sounds like you need an appropriately sized "screw extractor...

In forum Hardware, firmware and software help

3 years ago
Yes, I have the same. Mine is the result of delaying shipme...

In forum General discussion, announcements and releases

3 years ago
I ordered my printer in October with it (told them to hold i...

In forum General discussion, announcements and releases

3 years ago
Sections 7.2.2 and 7.2.6 in the manual deal with the reset b...

In forum General discussion, announcements and releases

3 years ago
I just got a notice from DHL that my textured sheet has ship...

In forum General discussion, announcements and releases

3 years ago
You didn't answer Joan on the extrusion multiplier question ...

In forum Hardware, firmware and software help

3 years ago
It sounds like you need some screw extractors. Hmmmm. I h...

In forum Hardware, firmware and software help

3 years ago
There was a spare in my kit (actually the instructions also ...

In forum Hardware, firmware and software help

3 years ago
strip the back right bed screw I assume that you have "stri...

In forum Hardware, firmware and software help

3 years ago
If the official PINDA Lift is one ziptie width above the noz...

In forum General discussion, announcements and releases

4 years ago
The PINDA sensor is exactly one ziptie (middle of it) away f...

In forum General discussion, announcements and releases

4 years ago
How do you know which firmware load to use? Thanks They a...

In forum Hardware, firmware and software help

4 years ago
Here’s a collection of what I consider the most useful “core...

In forum General discussion, announcements and releases

4 years ago
Can somebody share Mr. Warkocki's S3D profile information he...

In forum General discussion, announcements and releases

4 years ago
Everyone should try these Simplify3D and Slic3R profiles by ...

In forum General discussion, announcements and releases

4 years ago
I already replied to an identical post of yours from a few h...

In forum Hardware, firmware and software help

4 years ago
Fuse blown?

In forum Hardware, firmware and software help

4 years ago
Maybe no one is reading that can solve that… but could anyon...

In forum Software (Archive)

4 years ago
Page 1 / 6
Share: