Notifications
Clear all
Rick Houlihan
Rick Houlihan
Group: Registered
Joined: 2021/10/04
Active Member
1
Hi Kamil, I recommend starting with this video: It sounds li...

In forum General discussion, announcements and releases

1 day ago
Awesome, exactly what I was looking for but could not see ev...

In forum How do I print this? (Printing help)

2 days ago
I am sure I am just clueless, but I cannot find where to set...

In forum How do I print this? (Printing help)

2 days ago
Good to hear you got it working, it might hiccup a few times...

In forum Assembly and first prints troubleshooting

5 days ago
This is exactly the case. Take time and assemble the unit v...

In forum General discussion, announcements and releases

6 days ago
Awesome. Good to hear you have a root cause now. Hopefully t...

In forum Assembly and first prints troubleshooting

7 days ago
The MMU will stop pushing when the IR sensor is tripped. It...

In forum Assembly and first prints troubleshooting

1 week ago
Pretty sure on my I3MK3S+ the IR sensor does not tip unless ...

In forum Assembly and first prints troubleshooting

1 week ago
This is normal behavior and all it means is that the printer...

In forum Hardware, firmware and software help

1 week ago
If your printer is an i3MK3S+ the only thing you need to do ...

In forum Hardware, firmware and software help

2 weeks ago
You should only need to install the chimney in a new printer...

In forum Hardware, firmware and software help

2 weeks ago
I agree with this. I have minimal issues when I use Prusamen...

In forum General discussion, announcements and releases

2 weeks ago
I am starting to see something similar...the MMU will fail w...

In forum Hardware, firmware and software help

2 weeks ago
The chimney is such a simple mechanism...when the filament m...

In forum General discussion, announcements and releases

2 weeks ago
I am not sure why so many people are complaining about this ...

In forum General discussion, announcements and releases

2 weeks ago
Share: