Notifications
Clear all
peter.l22
peter.l22
Group: Registered
Joined: 2017/11/11
Honorable Member
1
I've also gotten my MMU2 to work reasonably reliably. I can ...

In forum General discussion, announcements and releases

2 years ago
Is this MMU2 or MMU2S? The MMU2S doesn't require calibrating...

In forum Assembly and first prints troubleshooting

2 years ago
I think you could still loosely couple the gear at both ends...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Another suggestion: Use herringbone gears so the rack will s...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
You will most likely have to switch back to the Prusa heatbr...

In forum Hardware, firmware and software help

2 years ago
Meshmixer seems to be the best tool for splitting STLs. It's...

In forum Assembly and first prints troubleshooting

2 years ago
If you're not using a stock extruder then you'll need to adj...

In forum Assembly and first prints troubleshooting

2 years ago
If you're referring to the MMU firmware, then YES, the MMU h...

In forum Hardware, firmware and software help

2 years ago
I really like this concept, especially the ability to adjust...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
This sounds like a sensor problem. Check that both sensors (...

In forum Hardware, firmware and software help

2 years ago
You need to reduce the "Maximal Bridging Distance" in the Wi...

In forum How do I print this? (Printing help)

2 years ago
On the MMU2s the tube length does not need to be calibrated,...

In forum Assembly and first prints troubleshooting

2 years ago
I never said it would be impossible. Just that it would be a...

In forum General discussion, announcements and releases

2 years ago
It's really hard to tell what we're supposed to be looking a...

In forum Assembly and first prints troubleshooting

2 years ago
Lots of people have asked for a larger Prusa printer. I've b...

In forum General discussion, announcements and releases

2 years ago
No. Volumetric flow is an independent setting. For any given...

In forum General discussion, announcements and releases

2 years ago
It's how fast the extruder pushes material through the nozzl...

In forum General discussion, announcements and releases

2 years ago
It looks like you might be in "Mesh" mode. You need to click...

In forum How do I print this? (Printing help)

2 years ago
I've gotten a fairly hard (92A) TPU to work well. I created ...

In forum General discussion, announcements and releases

2 years ago
I've printed a lot of ABS on my MMU, and it works just fine....

In forum How do I print this? (Printing help)

2 years ago
Page 1 / 33
Share: