Notifications
Clear all
Bigdogbro1
Bigdogbro1
Group: Registered
Joined: 2017/11/10
Estimable Member
4
I'll wait until Prusa sets up a U.S.A. parts warehouse for i...

In forum General discussion, announcements and releases

3 years ago
In S3D don't you need the machine interface on-screen to the...

In forum Hardware, firmware and software help

3 years ago
Thanks for the detailed answer information.

In forum Hardware, firmware and software help

3 years ago
Octoprint question

In forum Hardware, firmware and software help

3 years ago
Can you still make printer TUNE adjustments from the printer...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
If I seen the video correctly it looked like the lead screw ...

In forum Assembly and first prints troubleshooting

3 years ago
I have two MK3 kits that have the same thing happening. Fro...

In forum Assembly and first prints troubleshooting

3 years ago
CORRECT PARTS HAVE ARRIVED! I received a new controller rea...

In forum Assembly and first prints troubleshooting

3 years ago
I am finding that the signal information does not match up o...

In forum Hardware, firmware and software help

3 years ago
Thank you all for your generous replies and insight to my qu...

In forum General discussion, announcements and releases

3 years ago
A. Would anyone connect the PC USB to a RPi3 and then the RP...

In forum General discussion, announcements and releases

3 years ago
Thank you Olef. The information is helpful in understanding...

In forum General discussion, announcements and releases

3 years ago
Raspberry Pi3 and Arduino Zero/W Operation

In forum General discussion, announcements and releases

3 years ago
Thank you so much for the help!

In forum Hardware, firmware and software help

3 years ago
LCD board Schematics

In forum Hardware, firmware and software help

3 years ago
Thanks for all the comments. I have a Toshiba Flashair W-03...

In forum General discussion, announcements and releases

3 years ago
Ours was ordered 7 weeks ago and has all the extruder upgrad...

In forum General discussion, announcements and releases

3 years ago
Thanks Guys! I would WiFi to the RPi3 then USB to the MK3. ...

In forum General discussion, announcements and releases

3 years ago
Raspberry Pi3 USB & wifi performance

In forum General discussion, announcements and releases

3 years ago
I think most importantly is to have the heat bed surface fla...

In forum Assembly and first prints troubleshooting

3 years ago
Page 1 / 12
Share: