ad.lamy
ad.lamy
Group: Registered
Joined: 2017/11/07
Estimable Member
4
I totally agree with antalife, When I first ordered the MMU2...

In forum General discussion, announcements and releases

11 months ago
My filament cutter work, I've tested it first with the 3.9.0...

In forum General discussion, announcements and releases

1 year ago
@wpegden I agree with you, but like I said in my previous po...

In forum How do I print this? (Printing help)

1 year ago
When I first ordered the MMU2, I was convinced that I would ...

In forum How do I print this? (Printing help)

1 year ago
@s-g-2008 To reduce color bleeding you can adjust the purge ...

In forum General discussion, announcements and releases

1 year ago
@s-g-2008 Hi, The load unload speed seems to be driven by th...

In forum General discussion, announcements and releases

1 year ago
@s-g-2008 Hi, You can solve this problem in prusa slicer, se...

In forum General discussion, announcements and releases

1 year ago
@ruben-w Let us know if you had loading issues recovered by ...

In forum Hardware, firmware and software help

1 year ago
@ruben-w Hi ruben-w, Here the link to my Front PTFE Holder.

In forum Hardware, firmware and software help

1 year ago
Cutter works with 3.9.0 rc1 with little modification, I've t...

In forum General discussion, announcements and releases

1 year ago
Spool join should work, if the filament is ejected from the ...

In forum General discussion, announcements and releases

1 year ago
After the first failde test of the new filament cutter, with...

In forum Hardware, firmware and software help

1 year ago
Hi, Out of curiosity I tested the new selector and 3.9.0 rc1...

In forum Hardware, firmware and software help

1 year ago
A) Over 50 B) Not recorded the duration, 2000 tool change is...

In forum General discussion, announcements and releases

1 year ago
Hi, take a look on this thread, I had the same nasty noise d...

In forum Hardware, firmware and software help

2 years ago
Try to tweak the extra loading distance in Prusa Slicer, thi...

In forum Assembly and first prints troubleshooting

2 years ago
Since the first time I look at the MK3S-MMU2 IR sensor chimn...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
Hi, I had a similar issue when flashing the mmu2s from linux...

In forum Hardware, firmware and software help

2 years ago
Hi, the springs comes from the MK3 with 2 springs idler door...

In forum Assembly and first prints troubleshooting

2 years ago
This append when the lever is just on the edge of the IR sen...

In forum Assembly and first prints troubleshooting

2 years ago
Page 1 / 6
Share:

Please Login or Register