Notifications
Clear all
Jason_M
Jason_M
Group: Registered
Joined: 2017/11/04
Trusted Member
3
Some good info there. thanks. I will check over stuff on th...

In forum Hardware, firmware and software help

8 months ago
Extruder skipping and under extruding

In forum Hardware, firmware and software help

8 months ago
thanks this is the first time I’ve ever had a possible expl...

In forum PrusaSlicer

10 months ago
What version are you using ? ive found that the new 2.3 ve...

In forum PrusaSlicer

10 months ago
After around 50 hours of good printing with no more skipped ...

In forum Hardware, firmware and software help

1 year ago
Little update. not sure exactly why, but I’m now closing in...

In forum Hardware, firmware and software help

1 year ago
Yeah. I realise the pinda itself isn’t the cause. Just odd t...

In forum Hardware, firmware and software help

1 year ago
Thanks for the suggestion as to what to look at next. I’ll c...

In forum Hardware, firmware and software help

1 year ago
Doesn’t look like the nozzle is clogged. Two clean cold pul...

In forum Hardware, firmware and software help

1 year ago
I’m trying another cold pull or two using the explicit instr...

In forum Hardware, firmware and software help

1 year ago
That white blob thing didn’t fix the issue. guess I’ll try ...

In forum Hardware, firmware and software help

1 year ago
I got this that I think is ASA out of the top of the hot end...

In forum Hardware, firmware and software help

1 year ago
Just tried the cold pull using pla and the method in the lin...

In forum Hardware, firmware and software help

1 year ago
Thanks for the info. Good to know. the top two in the pic s...

In forum Hardware, firmware and software help

1 year ago
I’ll try the prusa recommendation next. See if that improves...

In forum Hardware, firmware and software help

1 year ago
Here’s how I did it. heat to 260°. Load ASA. Allow to cool ...

In forum Hardware, firmware and software help

1 year ago
This was the first pull. Attached.  B564EEB1-0487-41...

In forum Hardware, firmware and software help

1 year ago
Here’s the results of two cold pulls using ASA. time will t...

In forum Hardware, firmware and software help

1 year ago
I’m going to try a few cold pulls and see if that removes an...

In forum Hardware, firmware and software help

1 year ago
The hot end has never been disassembled from the prusa facto...

In forum Hardware, firmware and software help

1 year ago
Page 1 / 3
Share: