Activity
 
Notifications
Clear all
Steve
Steve
Group: Registered
Joined: 2017/10/28
Estimable Member
4
There is a small area in the lower left corner of the print ...

In forum General discussion, announcements and releases

2 months ago
Google says that acetone, alcohol, or paint thinner will dis...

In forum General discussion, announcements and releases

3 months ago
Try slicing the object with 3 or 4 walls so it prints as all...

In forum PrusaSlicer

4 months ago
I also design in inches. The last step before saving as STL ...

In forum PrusaSlicer

5 months ago
Personally, I would keep all the machines the same. Then you...

In forum General discussion, announcements and releases

7 months ago
Just be aware that some generic nozzles have short threads a...

In forum General discussion, announcements and releases

10 months ago
I am on my 6th nozzle after 7450m of filament and 178d 19h, ...

In forum General discussion, announcements and releases

10 months ago
I may have the same problem. The filament sensor works great...

In forum Assembly and first prints troubleshooting

10 months ago
It shouldn't matter if you have enough layers of the top col...

In forum PrusaSlicer

1 year ago
It may be that the previous layers do not get a chance to co...

In forum Assembly and first prints troubleshooting

1 year ago
I just leave the last roll on the machine. My activity often...

In forum General discussion, announcements and releases

1 year ago
Fonts are tricky when the widths are between two and three f...

In forum General discussion, announcements and releases

1 year ago
Using the needle to try to dislodge a jam is sometimes the q...

In forum Hardware, firmware and software help

1 year ago
I agree. Something is loose. Belts loose enough to cause tha...

In forum Assembly and first prints troubleshooting

1 year ago
My local Sam's Club has 2x32 ounce bottles of 91% IPA for ar...

In forum General discussion, announcements and releases

1 year ago
Wow, those prints look really bad. I looks like the material...

In forum How do I print this? (Printing help)

2 years ago
I use two part epoxy with a few threaded rod pins to give ex...

In forum General discussion, announcements and releases

2 years ago
If you have the CAD file, I would suggest making the lines 0...

In forum How do I print this? (Printing help)

2 years ago
Definitely the seam. Hollow cylinders start the next layer ...

In forum How do I print this? (Printing help)

2 years ago
Mine does it occasionally. It was usually the middle one on...

In forum Hardware, firmware and software help

2 years ago
Page 1 / 7
Share: