Activity
 
Notifications
Clear all
Steve
Steve
Group: Registered
Joined: 2017/10/28
Estimable Member
4
There is a small area in the lower left corner of the print ...

In forum General discussion, announcements and releases

2 weeks ago
Google says that acetone, alcohol, or paint thinner will dis...

In forum General discussion, announcements and releases

1 month ago
Try slicing the object with 3 or 4 walls so it prints as all...

In forum PrusaSlicer

3 months ago
I also design in inches. The last step before saving as STL ...

In forum PrusaSlicer

4 months ago
Personally, I would keep all the machines the same. Then you...

In forum General discussion, announcements and releases

6 months ago
Just be aware that some generic nozzles have short threads a...

In forum General discussion, announcements and releases

8 months ago
I am on my 6th nozzle after 7450m of filament and 178d 19h, ...

In forum General discussion, announcements and releases

8 months ago
I may have the same problem. The filament sensor works great...

In forum Assembly and first prints troubleshooting

8 months ago
It shouldn't matter if you have enough layers of the top col...

In forum PrusaSlicer

11 months ago
It may be that the previous layers do not get a chance to co...

In forum Assembly and first prints troubleshooting

1 year ago
I just leave the last roll on the machine. My activity often...

In forum General discussion, announcements and releases

1 year ago
Fonts are tricky when the widths are between two and three f...

In forum General discussion, announcements and releases

1 year ago
Using the needle to try to dislodge a jam is sometimes the q...

In forum Hardware, firmware and software help

1 year ago
I agree. Something is loose. Belts loose enough to cause tha...

In forum Assembly and first prints troubleshooting

1 year ago
My local Sam's Club has 2x32 ounce bottles of 91% IPA for ar...

In forum General discussion, announcements and releases

1 year ago
Wow, those prints look really bad. I looks like the material...

In forum How do I print this? (Printing help)

1 year ago
I use two part epoxy with a few threaded rod pins to give ex...

In forum General discussion, announcements and releases

2 years ago
If you have the CAD file, I would suggest making the lines 0...

In forum How do I print this? (Printing help)

2 years ago
Definitely the seam. Hollow cylinders start the next layer ...

In forum How do I print this? (Printing help)

2 years ago
Mine does it occasionally. It was usually the middle one on...

In forum Hardware, firmware and software help

2 years ago
Page 1 / 7
Share: