Neolker
Neolker
Group: Registered
Joined: 2017/10/25
Estimable Member
4
Odmaštění a rovinnost bedu.

In forum Nejlepší výtisky & tiskové tipy

2 months ago
Arcy jsou G1 myslím, že? Marlin podporuje pouze G0 a vzhlede...

In forum Obecná diskuze, oznámení a novinky

2 months ago
As I know, this functionality is not implemented yet.

In forum Hardware, firmware and software help

1 year ago
It might help reduce values of serial resistors around J8 co...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
It was me, and this was only unconfirmed sneak peek, when yo...

In forum General discussion, announcements and releases

1 year ago
Kdyby někomu přece jen uniklo, tak PR má v eshopu levnější P...

In forum Obecná diskuze, oznámení a novinky

1 year ago
@mr-b OK, then you can have a look at but it will be more e...

In forum General discussion, announcements and releases

1 year ago
@chocki Actually I have rich experience with RFID / NFC deve...

In forum Hardware, firmware and software help

1 year ago
Hi, just use this map and find near by Prusa owner 😉

In forum General discussion, announcements and releases

1 year ago
Pages 35 - 45, you are welcome 🙂

In forum General discussion, announcements and releases

1 year ago
Great idea, I have access to x-ray too. Sorry about the cabl...

In forum Hardware, firmware and software help

1 year ago
@geoper2 I guess it causes humidity in flex filament. It has...

In forum How do I print this? (Printing help)

1 year ago
The true is that support of Simplify3D really sucks and unfo...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@volt Lze to spočítat na téhle kalkulačce poměrně jednoduše ...

In forum Hardware, firmware a software (Pomoc)

1 year ago
@mreynolds0404 It looks like humidity in flex filament (due ...

In forum How do I print this? (Printing help)

1 year ago
Ahoj, je možné koupit novou po přihlášení zde: pokud se ti ...

In forum Hardware, firmware a software (Pomoc)

1 year ago
@martinnaujocks Thera are few free GPIO on Buddy board (plan...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@dare-durden-new Ahoj, to je šev (seam) na modelu, kde začín...

In forum Obecná diskuze, oznámení a novinky

1 year ago
Hi Martin, I have checked schematic and there are only +24V,...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 year ago
@area51 According to spare part it is a fan by Delta Electro...

In forum General discussion, announcements and releases

1 year ago
Page 1 / 9
Share:

Please Login or Register