darKing
darKing
Group: Registered
Joined: 2017/10/18
Trusted Member
3
Does it still occur when settings -> mesh bed lvl -> c...

In forum Hardware, firmware and software help

1 year ago
Hi guys, it's me again, the TO. I'm somewhat proud that this...

In forum Hardware, firmware and software help

1 year ago
Hm, are you sure it's not the start / end of the line? Somet...

In forum Hardware, firmware and software help

1 year ago
Hi vintage, no it's nice and cozy at work. 🙂 But yeah, a ve...

In forum Hardware, firmware and software help

1 year ago
Display quite "sticky" (slow refresh)

In forum Hardware, firmware and software help

1 year ago
Ok, jurst ordered a new one. Together with the MK3 -> MK3...

In forum General discussion, announcements and releases

2 years ago
pssssssst! Don't say this so loud. I am kind of a nerd and d...

In forum General discussion, announcements and releases

2 years ago
I also expected a different reading between the "internal" s...

In forum General discussion, announcements and releases

2 years ago
Is this a failing Thermistor, or something else? (Hotend Tem...

In forum General discussion, announcements and releases

2 years ago
Can you guys try something for me? For me, in 3.4.0 RC2 the...

In forum General discussion, announcements and releases

3 years ago
Can't tell about M916 but there is a new Firmware 3.4.0 RC w...

In forum Hardware, firmware and software help

3 years ago
Now that you say it: Yes Sir, that's correct. What does that...

In forum Assembly and first prints troubleshooting

3 years ago
The Bump in your last pics is the same height as where the d...

In forum Assembly and first prints troubleshooting

3 years ago
Hm, I printed with Clear HT and had no problems. Have you al...

In forum Assembly and first prints troubleshooting

3 years ago
FWIW, I'm also encountering fake crash detections on the y-a...

In forum Hardware, firmware and software help

3 years ago
Also Z-Hopping ("retraction vertical lift" in S3D) sometimes...

In forum Hardware, firmware and software help

3 years ago
I think your nozzle is running over the infill, that's all. ...

In forum Hardware, firmware and software help

3 years ago
Some more stuff to think about. I thought it was time for so...

In forum Hardware, firmware and software help

3 years ago
"We redesigned the Extruder body so there is NO gap and TPU ...

In forum General discussion, announcements and releases

3 years ago
🙂 On the Y-Axis it's the other way around. So if you asseml...

In forum Assembly and first prints troubleshooting

3 years ago
Page 1 / 5
Share:

Please Login or Register