Notifications
Clear all
Zachary Lance
Zachary Lance
Group: Registered
Joined: 2017/10/18
Active Member
1
They are the stepper motors they can oscillate and make a mu...

In forum General discussion, announcements and releases

2 years ago
The first thing I would do is to double-check the electronic...

In forum Assembly and first prints troubleshooting

2 years ago
@tim-m30 That happened to me, definitely could be an issue w...

In forum Hardware, firmware and software help

2 years ago
Hi, first thing I would do would to check the pinda probe, i...

In forum Hardware, firmware and software help

2 years ago
Hi, you can either delete the folder and then empty the recy...

In forum General software discussion

2 years ago
Yes this used to happen to me a lot. Try to clean it, in cas...

In forum Assembly and first prints troubleshooting

2 years ago
Yess! This is a major problem for me, I switched back to 3.7...

In forum General discussion, announcements and releases

2 years ago
When I first got my printer the lamps plugged into the power...

In forum General discussion, announcements and releases

2 years ago
Have you tried upgrading the firmware to 3.7.2? And if you h...

In forum Hardware, firmware and software help

2 years ago
The silver filament that I got with my mk3 is definitely not...

In forum General discussion, announcements and releases

2 years ago
Yes, I would recommend you upgrade it as soon as it appeared...

In forum General discussion, announcements and releases

2 years ago
I had an issue with the PSU when I woke up from sleep and th...

In forum Hardware, firmware and software help

4 years ago
Share: