Notifications
Clear all
ewout.s
ewout.s
Group: Registered
Joined: 2017/10/15
Eminent Member
2
Could this be caused by a mismatch of firmware between the p...

In forum Assembly and first prints troubleshooting

3 years ago
And the resulting print (apologies for the poor quality but ...

In forum Assembly and first prints troubleshooting

3 years ago
I don't know if the causes are similar but I recommend to ch...

In forum Assembly and first prints troubleshooting

3 years ago
Most plastics will survive outdoor conditions (mainly sun ex...

In forum How do I print this? (Printing help)

3 years ago
Thanks for the heads up, ordered some Prusament Galaxy Black...

In forum General discussion, announcements and releases

3 years ago
Does anybody know where I can purchase something like this a...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Thank you kindly Prusa for the voucher, much appreciated her...

In forum General discussion, announcements and releases

3 years ago
I have built the IKEA Lack enclosure but it seems to be too ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Smallest I went is M5x40 with a 0.8mm pitch which came out p...

In forum How do I print this? (Printing help)

4 years ago
Dito here. Just went through the menu after upgrading to 3.2...

In forum General discussion, announcements and releases

4 years ago
Almost complete: Awesome. Consider that method of runnin...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Hmm, looks like I'll have some open gaps in my enclosure... ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Looks like the beginning of Prusa implementing the changes s...

In forum Hardware, firmware and software help

4 years ago
I'm slowly working my way through the enclosure build. Quite...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Bought 3 Lack tables today. First impression after assemblin...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
I bought a pi0W before becoming aware of the high load on th...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Vibration can be eliminated either by using the paver as oth...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Seriously considered racing to Ikea yesterday as I'm fed up ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Thank you for posting that. Well thought through that one, w...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Interesting approach. I haven't printed with ABS yet, closes...

In forum Others (Archive)

4 years ago
Page 1 / 3
Share: