Notifications
Clear all
joris.m
joris.m
Group: Registered
Joined: 2017/10/08
Estimable Member
4
I managed to do my print now, but I am suffering from incons...

In forum How do I print this? (Printing help)

3 years ago
Max volumetric speed is indeed a good global speed limiter, ...

In forum How do I print this? (Printing help)

3 years ago
Isn't it a bit strange to release an official firmware updat...

In forum Hardware, firmware and software help

3 years ago
Knowing how handy I am with stickers over big surfaces that ...

In forum General discussion, announcements and releases

3 years ago
Cross-post, but this is how I solved it: - add 0.05mm to th...

In forum How do I print this? (Printing help)

3 years ago
Don't know if it can be of any assistance, but I found the d...

In forum How do I print this? (Printing help)

3 years ago
I don't really care about the coated one, but what bothers m...

In forum General discussion, announcements and releases

3 years ago
Spring steel sheet availability

In forum General discussion, announcements and releases

3 years ago
3DXPRO LOW-GLOSS PETG. Jams when printing big surfaces.

In forum How do I print this? (Printing help)

3 years ago
FYI I print PLA at 230 degrees, PETG at 245, and I checked t...

In forum How do I print this? (Printing help)

3 years ago
PETG + PLA, bad layer adhesion in PETG layers

In forum How do I print this? (Printing help)

3 years ago
I have similar issues when mixing PETG and PLA. I'm trying t...

In forum Assembly and first prints troubleshooting

3 years ago
#yolo I just ordered the mk2.5 upgrade + the mmu1 to mmu2 u...

In forum General discussion, announcements and releases

3 years ago
Re: ngen layer adhesion issues in MMU mode

In forum How do I print this? (Printing help)

3 years ago
ngen layer adhesion issues in MMU mode

In forum How do I print this? (Printing help)

3 years ago
I would install ventilation. Doing PLA myself with my mk2MM...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
I guess it would be less precise.

In forum Others (Archive)

4 years ago
You should do the opposite. You should have less live Z for ...

In forum Others (Archive)

4 years ago
OctoPi uses it as a normal webcam. No configuration needed. ...

In forum Others (Archive)

4 years ago
Nope. Nobody can get them. Not even mk3 customers.

In forum Others (Archive)

4 years ago
Page 1 / 10
Share: