Notifications
Clear all
keith.m10
keith.m10
Group: Registered
Joined: 2017/10/07
Eminent Member
2
My filament sensor also is not working, and on looking/probi...

In forum Assembly and first prints troubleshooting

3 years ago
Well I myself hope I do not have to wait a year for the V2 v...

In forum General discussion, announcements and releases

3 years ago
I though the no activity after XX minutes but still heated s...

In forum Hardware, firmware and software help

4 years ago
I would try a couple degree cooler extruder temp. YMMV.

In forum How do I print this? (Printing help)

4 years ago
Ok. I've mainly been programming with interpreted languages ...

In forum General discussion, announcements and releases

4 years ago
The motor bodies are floating as they have no electrical con...

In forum Others (Archive)

4 years ago
I calibrated when I built it, and the one time when I moved ...

In forum Others (Archive)

4 years ago
I know the old version of the Mini Rambo board with the olde...

In forum Improvements (Archive)

4 years ago
I would recommend checking the forums for the Ultimaker as t...

In forum Others (Archive)

4 years ago
Your PENTA probe is extending down too far and reduced the Z...

In forum Others (Archive)

4 years ago
Try e3d-online for a replacement bowden collet, in the hot e...

In forum Others (Archive)

4 years ago
I have stopped getting Makergeeks a couple months ago now! I...

In forum Others (Archive)

4 years ago
I just looked at my tracking, and the link they emailed me a...

In forum General discussion, announcements and releases

4 years ago
Have you tried a really strong IPA(90% or higher) to try to ...

In forum Others (Archive)

4 years ago
The drivers are usually programmed in serial order, so the f...

In forum Others (Archive)

4 years ago
The interface chip on the O.P. picture looks to have a poorl...

In forum Others (Archive)

4 years ago
Thin oils will not really help the dry ball bearings to be a...

In forum Hardware, firmware and software help

4 years ago
I noticed that there is a header marked 5V on the Einsy boar...

In forum Others (Archive)

4 years ago
There is no 5 volt or 24 volt version. It is a ~9 volt to ~...

In forum Others (Archive)

4 years ago
The noctua fan on the print head is 12v. That may be, but ...

In forum Others (Archive)

4 years ago
Page 1 / 2
Share: