Notifications
Clear all
blunstone
blunstone
Group: Registered
Joined: 2017/10/05
Eminent Member
2
Thanks Joan, funnily enough I was in Manchester earlier this...

In forum How do I print this? (Printing help)

3 months ago
Thanks Diem - I can travel in hope!

In forum How do I print this? (Printing help)

3 months ago
PET for outside use

In forum How do I print this? (Printing help)

3 months ago
Acetone won't dissolve PLA. Have you seen this, Tom is good...

In forum Others (Archive)

4 years ago
Hi, I'm relatively new to this so take these suggestions on...

In forum Others (Archive)

4 years ago
Hi there, Check this out Try PLA first then PETG for a c...

In forum Others (Archive)

4 years ago
Thx to all trying to help and I will go through each suggest...

In forum Others (Archive)

4 years ago
If the tensioner etc is OK and the extruder can't cope with ...

In forum Others (Archive)

4 years ago
The last filament should have read extruder

In forum Others (Archive)

4 years ago
Self-assembled. I'm pretty sure the gears tension and the a...

In forum Others (Archive)

4 years ago
The dreaded Bondtech click and Flow setting

In forum Others (Archive)

4 years ago
thx

In forum Print tips (Archive)

4 years ago
Filaments in Slic3r PE

In forum Print tips (Archive)

4 years ago
This happens every time for me. I preheat the hot end as in...

In forum Others (Archive)

4 years ago
I really don't think so. My kit, despatched yesterday, is cr...

In forum General discussion, announcements and releases

4 years ago
Thx for responding and for the advice. As I get ready for m...

In forum Assembly and first prints troubleshooting

4 years ago
Hi, This is my first serious post as a noob. Firstly can I...

In forum Assembly and first prints troubleshooting

4 years ago
5th Oct, got tracking last Tuesday

In forum General discussion, announcements and releases

4 years ago
UPS are reporting they have collected my kit, so I think shi...

In forum General discussion, announcements and releases

4 years ago
My status has changed this morning to "order being packed"

In forum General discussion, announcements and releases

4 years ago
Share: