Notifications
Clear all
RotaryDane
RotaryDane
Group: Registered
Joined: 2017/09/30
Eminent Member
2
It’s is very dry in your home? The problem persisting over ...

In forum Others (Archive)

4 years ago
i hope they bring it back, and just allow a toggle of LA vs ...

In forum Others (Archive)

4 years ago
Final? I hope not 😆 Of course we know what you mean an...

In forum Others (Archive)

4 years ago
New (Final?) Firmware released!

In forum Others (Archive)

4 years ago
You're making a strong case for a pi with a frame-mounted sc...

In forum Others (Archive)

4 years ago
It wouldn't hurt to have a quick-access shortcut to changing...

In forum Others (Archive)

4 years ago
You have to clarify what do you mean? Meanwhile, here are a...

In forum Others (Archive)

4 years ago
There were some posts stating that it could be related to vi...

In forum How do I print this? (Printing help)

4 years ago
Silicone socks seems like a good idea. I noticed that there ...

In forum Others (Archive)

4 years ago
Can also back this up. First noticed these bubbles after pri...

In forum Others (Archive)

4 years ago
What I was really getting at was that just using another per...

In forum General discussion, announcements and releases

4 years ago
Have had some time to tweak some settings, so am aiming to c...

In forum General discussion, announcements and releases

4 years ago
What amount of cooling did you have active during these prin...

In forum Others (Archive)

4 years ago
What amount of cooling did you have active during these prin...

In forum Others (Archive)

4 years ago
I don’t think you should use it on the nozzle thread, or on ...

In forum Others (Archive)

4 years ago
Your logic with the thermal paste seems good, although remem...

In forum Others (Archive)

4 years ago
Do you own a set of digital calipers? If not I'd suggest you...

In forum Others (Archive)

4 years ago
You can also try holding a small piece of filament over a na...

In forum Prusa i3 kit (Archive)

4 years ago
Which slicer you are using has a lot to say as Sluc3r conseq...

In forum Others (Archive)

4 years ago
You could attempt a Temp. Calibration and see if it helps. W...

In forum Others (Archive)

4 years ago
Page 1 / 2
Share: