Notifications
Clear all
kerry.c
kerry.c
Group: Registered
Joined: 2017/09/29
Active Member
1
Guys, I think I have resolved the issue. I completely disas...

In forum Hardware, firmware and software help

1 year ago
@pcweber Can you shed some insight as to what causes the gea...

In forum Hardware, firmware and software help

1 year ago
Issue: Filament not getting through?

In forum Hardware, firmware and software help

1 year ago
...printing one piece at a time. The Simplify3D Factory fi...

In forum Others (Archive)

4 years ago
in here Reviewed that thread (and some external searching)...

In forum Others (Archive)

4 years ago
Page 9, PLA filament (or PETG, APLA, htPLA, PC-max....) not...

In forum Others (Archive)

4 years ago
230 for the Hot-end is way too much for PLA.... And the bed...

In forum Others (Archive)

4 years ago
have a look in this thread Simplify3D settings regards ...

In forum Others (Archive)

4 years ago
I think in Simplify3D in Under HELP/Configuration Assistant ...

In forum Others (Archive)

4 years ago
Okay, I have adjusted the settings as I think you're suggest...

In forum Others (Archive)

4 years ago
230 for the Hot-end is way too much for PLA.... And the bed...

In forum Others (Archive)

4 years ago
What temperature are you using on the Bed? The bed tempera...

In forum Others (Archive)

4 years ago
You can try to squish the first layer a little better by adj...

In forum Others (Archive)

4 years ago
What material are you printing in? Sorry, should have clar...

In forum Others (Archive)

4 years ago
Edges lifting – Cessna 152 Trainer

In forum Others (Archive)

4 years ago
Share: