Notifications
Clear all
The Plastic Shed
The Plastic Shed
Group: Registered
Joined: 2017/09/29
Estimable Member
4
After installing this version it completely screwed up my fi...

In forum General discussion, announcements and releases

2 years ago
these do not work. Absolute nonsense but you do need to ch...

In forum Improvements (Archive)

3 years ago
or mine ... has to be designed for the job - which my hyper...

In forum General discussion, announcements and releases

3 years ago
Then you won't get a larger print bed on a Prusa design if y...

In forum General discussion, announcements and releases

3 years ago
Only good way to handle larger build plates is to stop using...

In forum General discussion, announcements and releases

3 years ago
Pretty much exclusively Slic3rPE and Simplify 3D. For whate...

In forum General discussion, announcements and releases

3 years ago
I started doing the Z height this way You can get pretty...

In forum Assembly and first prints troubleshooting

3 years ago
Leave the extrusion multiplier alone as this has global impa...

In forum Assembly and first prints troubleshooting

3 years ago
Sorry yes - post self test - numbers are still too high if y...

In forum Assembly and first prints troubleshooting

3 years ago
Belt status is updated only during XYZ calibration and your ...

In forum Assembly and first prints troubleshooting

3 years ago
You need to slacken off the Y and then remove it from the ca...

In forum Assembly and first prints troubleshooting

3 years ago
I wouldn't be happy if a 'professionally' built printer was ...

In forum Assembly and first prints troubleshooting

3 years ago
Why bother ? If you set up a printer profile in Slic3r PE y...

In forum Hardware, firmware and software help

3 years ago
Afraid this is one of those learning experiences. Please don...

In forum Hardware, firmware and software help

3 years ago
if it isnt making noise and isnt affecting printing then don...

In forum Hardware, firmware and software help

3 years ago
Does sound like a gcode / SD card issue, possibly an SD card...

In forum Hardware, firmware and software help

3 years ago
Yeh I have a full fat Pi attached via USB, I use the specifi...

In forum Hardware, firmware and software help

3 years ago
No argument, not handled well at all, whilst I'm no longer c...

In forum General discussion, announcements and releases

3 years ago
It is, calibrated mine using that and my first layers have i...

In forum Hardware, firmware and software help

3 years ago
Here Here .... I was one of those that got pretty 'irritate...

In forum General discussion, announcements and releases

3 years ago
Page 1 / 7
Share: