Activity
 
Notifications
Clear all
jan.b5
jan.b5
Group: Registered
Joined: 2016/06/15
Eminent Member
2
Joan, Thank you for your excellent and comprehensive answer.

In forum General discussion, announcements and releases

2 years ago
TCO of the SL1

In forum General discussion, announcements and releases

2 years ago
I had the same problem and noticed that I installed a MK2.5S...

In forum Hardware, firmware and software help

2 years ago
Check out my thread: Maybe you have the same problem...

In forum Assembly and first prints troubleshooting

3 years ago
Maybe checkout my thread: TL;DR In my case the problem was...

In forum Hardware, firmware and software help

3 years ago
The extruder-idler printed part has no tolerance between the...

In forum Hardware, firmware and software help

3 years ago
Found the reason for the strange sounds and the underextrusi...

In forum Hardware, firmware and software help

3 years ago
Update: That print that I posted a picture of the first laye...

In forum Hardware, firmware and software help

3 years ago
Strange Extruder Sounds

In forum Hardware, firmware and software help

3 years ago
Have had no real intuitive sense of how tight the sprung ext...

In forum Assembly and first prints troubleshooting

3 years ago
I had the same problem and I'm not sure how I came over it, ...

In forum Assembly and first prints troubleshooting

3 years ago
I had some underextrusion problems (skipping extruder) in th...

In forum Assembly and first prints troubleshooting

3 years ago
And here's the answer to our question: They print it with ...

In forum Print tips (Archive)

3 years ago
Interesting... I am about to print a set of replacement part...

In forum Print tips (Archive)

3 years ago
If I put a little piece of plastic in the x-cover back then ...

In forum Assembly and first prints troubleshooting

4 years ago
The problem is that Prusa has a mistake in the X axis parts:...

In forum Assembly and first prints troubleshooting

4 years ago
Thank you, that's a good idea. It was the first layer. My g...

In forum Others (Archive)

4 years ago
Small flaw in otherwise perfect print

In forum Others (Archive)

4 years ago
Love this material : PC, very smooth and easy to print. It'...

In forum Improvements (Archive)

4 years ago
I think these are Omrom SS-5GL microswitches. I ordered some...

In forum Others (Archive)

4 years ago
Page 1 / 2
Share: