Activity
 
Notifications
Clear all
kelchm
kelchm
Group: Registered
Joined: 2017/09/24
Eminent Member
2
Has anyone seen any actual improvement in this with firmware...

In forum Hardware, firmware and software help

4 years ago
Just chiming in here that I'm also seeing signs wear on my g...

In forum Others (Archive)

4 years ago
Has anyone heard anything on availability recently? I was to...

In forum Others (Archive)

4 years ago
Before the Mk3 I used the same sheet of 0.03" PEI for over a...

In forum Others (Archive)

4 years ago
I created this thread a few weeks back to track ideas for th...

In forum General discussion, announcements and releases

4 years ago
I keep hoping that one day S3D's configuration management wi...

In forum General discussion, announcements and releases

4 years ago
1. RPi will need a battery backup to stay powered. Cutting p...

In forum Others (Archive)

4 years ago
1. RPi will need a battery backup to stay powered. Cutting p...

In forum Others (Archive)

4 years ago
Is there any specific maximum temperature to use on MK3's he...

In forum Others (Archive)

4 years ago
I've had good luck with both eSun and Hatchbox PETG.

In forum Others (Archive)

4 years ago
Can you try a different roll of PETG? It's possible you got ...

In forum Others (Archive)

4 years ago
Received my replacement power supply today, but one of the 3...

In forum Hardware, firmware and software help

4 years ago
I'd like to add: Fix faster upload speeds from octoprint to...

In forum Others (Archive)

4 years ago
I'd like to add: Fix faster upload speeds from octoprint to...

In forum Others (Archive)

4 years ago
Received my replacement power supply today, but one of the 3...

In forum Hardware, firmware and software help

4 years ago
PETG should stick to clean PEI with no issue at all. You're ...

In forum Others (Archive)

4 years ago
Improving the OctoPrint and Prusa i3 MK3 User Experience

In forum Others (Archive)

4 years ago
Same topic here : Thomas Thanks. That helps a little, b...

In forum Others (Archive)

4 years ago
I print almost exclusively with PETG and have had zero issue...

In forum Others (Archive)

4 years ago
Technically you shouldn't do it, just like you shouldn't ass...

In forum Others (Archive)

4 years ago
Page 1 / 2
Share: