Activity
 
Notifications
Clear all
gtmans
gtmans
Group: Registered
Joined: 2021/08/02
Active Member
1
Unbelievable! Thanx for all the effort. The .3MF's are in th...

In forum How do I print this? (Printing help)

7 hours ago
OK thx! Like this?  prusa-stands.zip

In forum How do I print this? (Printing help)

9 hours ago
Sure! You are more then welcome. Could not upload here so pl...

In forum How do I print this? (Printing help)

9 hours ago
I checked all the screws and the belt tension and cannot fin...

In forum How do I print this? (Printing help)

12 hours ago
Thx. I checked all the screws. Nothing loose. Must be a soft...

In forum How do I print this? (Printing help)

1 day ago
Vertical lines not vertical

In forum How do I print this? (Printing help)

1 day ago
I don't mind the noise but am carefull and single newbee. No...

In forum Hardware, firmware and software help

5 months ago
Thanx I checked that but could not find anything loose. Some...

In forum Hardware, firmware and software help

5 months ago
Vibrating heatbed after 25d printing time and 635mtr filamen...

In forum Hardware, firmware and software help

5 months ago
Its my first 3D printer and I built it just a month ago. Pri...

In forum General discussion, announcements and releases

6 months ago
Its my first 3D printer and I built it just a month ago. Pri...

In forum General discussion, announcements and releases

6 months ago
I used acetone after about every 10 prints or so. Just a wip...

In forum General discussion, announcements and releases

6 months ago
So now I understand I ruined my first pei sheet by using ac...

In forum General discussion, announcements and releases

6 months ago
Share: