Activity
 
Notifications
Clear all
ibn
ibn
Group: Registered
Joined: 2017/09/21
Trusted Member
3
Hi Jakob, did you find a profile yet? I was looking for a 0....

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 years ago
To repeat what Peter said, did you also check the grub srews...

In forum Assembly and first prints troubleshooting

4 years ago
Have a look at the release notes, as far as I understand the...

In forum General discussion, announcements and releases

4 years ago
As far as I know that changing steps/mm, extrusion multiplie...

In forum How do I print this? (Printing help)

4 years ago
there's info about the one for the heated bed in this thread...

In forum Assembly and first prints troubleshooting

4 years ago
The "move" section is to place the modifier meshes, it works...

In forum Software (Archive)

4 years ago
I bet the printer is actually following the intended path, i...

In forum How do I print this? (Printing help)

4 years ago
Kevin, for horizontally orientated features your resolution...

In forum Print tips (Archive)

4 years ago
to adjust stuff like that you can use modifier meshes (this ...

In forum How do I print this? (Printing help)

4 years ago
japato, when you do the z-calibration as Brigandier said: o...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Do the lines coincide with the infill pattern? If so increas...

In forum Others (Archive)

4 years ago
First measurement and after moving Y axis holders as much as...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
are you sure the detail isn't there? Sometimes the rendering...

In forum Print tips (Archive)

4 years ago
Piotr, what is the setting for the extrusion width in your ...

In forum Print tips (Archive)

4 years ago
Slic3r 1.39.1 calculates the print time very accurately

In forum Others (Archive)

4 years ago
If you find a print sticking too much (despite the windex) t...

In forum Others (Archive)

4 years ago
checking the box "Print Settings" --> "Layers and perimet...

In forum Software (Archive)

4 years ago
Slic3r - save modifier mesh configuration

In forum Software (Archive)

4 years ago
1) Octoprint doesn't seem to register that the printer has s...

In forum General discussion, announcements and releases

4 years ago
if you have the clearance you can also tell slic3r to print ...

In forum Others (Archive)

4 years ago
Page 1 / 3
Share: