Activity
 
Notifications
Clear all
salsa
salsa
Group: Registered
Joined: 2017/09/17
Eminent Member
2
I am printing shield parts too and have tried and failed at ...

In forum PrusaSlicer

2 years ago
Gcode scheme to repeat prints?

In forum How do I print this? (Printing help)

2 years ago
@vintagepc Thanks! This is great 🙂

In forum Hardware, firmware and software help

2 years ago
@olef Yes of course cutting power will stop everything 🙂 It...

In forum Hardware, firmware and software help

2 years ago
@nikolai-r Seems like reset would work for my MK3 and have t...

In forum Hardware, firmware and software help

2 years ago
Oldish topic but I wonder if there's a way to wire up a real...

In forum Hardware, firmware and software help

2 years ago
What sheet to print on?

In forum How do I print this? (Printing help)

3 years ago
...after a couple of small pieces from the area where the ti...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Your Pinda wire probably has a break in it. ... wiggle the c...

In forum Hardware, firmware and software help

3 years ago
Thanks @mark.r19, the axes go out of alignment when trying t...

In forum Hardware, firmware and software help

3 years ago
Can't calibrate after a print. P.I.N.D.A. problem?

In forum Hardware, firmware and software help

3 years ago
I just run it with the standard PLA settings plus 5 degrees:...

In forum Print tips (Archive)

4 years ago
My filament sensor triggered with black PETG the day before ...

In forum Others (Archive)

4 years ago
I've had some success with PETG, but it's time to revisit my...

In forum Others (Archive)

4 years ago
fwiw I've used Pi's of different models in different capacit...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
I've upgraded my MK3 and stuck the Pi Zero W back on the hea...

In forum Others (Archive)

4 years ago
I keep having layer shift issues running OctoPrint 🙁 It has...

In forum General discussion, announcements and releases

4 years ago
Piling on the hot end/extruder suggestions: easy swapping wo...

In forum General discussion, announcements and releases

4 years ago
Did you remember to do the M502 and M500 to load the new con...

In forum General discussion, announcements and releases

4 years ago
The biggie for me is having true dual extrusion for model an...

In forum General discussion, announcements and releases

4 years ago
Page 2 / 3
Share: