Notifications
Clear all
Sidbitters
Sidbitters
Group: Registered
Joined: 2017/09/10
Eminent Member
2
Example of textured sheet print.  image0.jpeg

In forum General discussion, announcements and releases

2 years ago
In the file section in the Prusa Community on facebook there...

In forum General discussion, announcements and releases

3 years ago
Thanks for the information. I will remember to watch for thi...

In forum Hardware, firmware and software help

3 years ago
Ok, sounds like it should be shipped soon. I’m just printing...

In forum Hardware, firmware and software help

3 years ago
Has anyone received the 2.5 —>2.5s upgrade parts yet? I o...

In forum Hardware, firmware and software help

3 years ago
I replied to the email about receiving the sheet a while bac...

In forum General discussion, announcements and releases

3 years ago
I'm going with 10$ off the textured sheet with free shipping...

In forum Hardware, firmware and software help

3 years ago
Good, thanks. Usually my problem was getting it off the bed ...

In forum How do I print this? (Printing help)

4 years ago
Printing TPU

In forum How do I print this? (Printing help)

4 years ago
The magnetic bed would be nice but I was hoping for a more l...

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
I just received my shipping notice for my Nov 24th order so ...

In forum General discussion, announcements and releases

4 years ago
Thanks Lionel for pointing me in the right direction.

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
Use just the heatbed from 2.5 upgrade?

In forum User mods - OctoPrint, enclosures, nozzles, ...

4 years ago
You said bed correction is 50 microns. Isn't hyperfine adju...

In forum Assembly and first prints troubleshooting

4 years ago
You need to perfect the z level in the center and then use b...

In forum Others (Archive)

4 years ago
I just bought some Petg and printed the holder from the Pusa...

In forum Others (Archive)

4 years ago
Hi, I ordered the MK2.5 upgrade shortly after it was announc...

In forum Others (Archive)

4 years ago
I didn't think it would take six months..

In forum Others (Archive)

4 years ago
If your live z is set right and the mess was from the print ...

In forum Others (Archive)

4 years ago
I have the Mk2s with the Rambo 13 board. I have the latest r...

In forum Assembly and first prints troubleshooting

4 years ago
Page 1 / 2
Share: