Activity
 
Notifications
Clear all
BillC
BillC
Group: Registered
Joined: 2017/08/24
Reputable Member
5
Go to your item, select add to category, select a category. ...

In forum General discussion, announcements and releases

1 year ago
In Philippines - FB group 3DP4AC backlog of 20k face shields...

In forum Coronavirus (COVID-19)

1 year ago
Is there not enough information here in step 18 to help you?...

In forum General discussion, announcements and releases

1 year ago
@jon-n2 Try the 3.9.0 or the new 3.9.1 from GitHub?

In forum Assembly and first prints troubleshooting

1 year ago
Use the Prusaprinters World map to find users near you who o...

In forum General discussion, announcements and releases

2 years ago
1) If this was a solution you would expect Prusa to modify t...

In forum Hardware, firmware and software help

2 years ago
Hold the removed nozzle over a heat source (I have used the ...

In forum Assembly and first prints troubleshooting

2 years ago
Success. Hmm looks like a mixture of random seam setting and...

In forum General discussion, announcements and releases

2 years ago
Can't see anything on the first post. Clicking the Capture.P...

In forum General discussion, announcements and releases

2 years ago
It's quite possible that PINDA clamp was not quite tight eno...

In forum Hardware, firmware and software help

2 years ago
@ian-s3, @ajisis, Thanks for trying that. Colour me disappoi...

In forum Hardware, firmware and software help

2 years ago
Would be interesting to get the measurement from z-frame edg...

In forum Hardware, firmware and software help

2 years ago
@andrewrussellwest I think we expected a photo of a print sh...

In forum General discussion, announcements and releases

2 years ago
Can you check Print settings in advanced mode - do you have ...

In forum PrusaSlicer

2 years ago
Can you show the completed upgrade, with a close up of the f...

In forum How do I print this? (Printing help)

2 years ago
You may be able to find someone a little closer than that. U...

In forum Assembly and first prints troubleshooting

2 years ago
In this thread OP @kenny-b2 says he was able to resolve the...

In forum Hardware, firmware and software help

2 years ago
The left end fan should NOT run as soon as the printer is tu...

In forum Assembly and first prints troubleshooting

2 years ago
Paul, Did you get yourself sorted out? If not, then after yo...

In forum Assembly and first prints troubleshooting

2 years ago
In the MK2 start code replace M104 S[first_layer_temperature...

In forum General discussion, announcements and releases

2 years ago
Page 1 / 18
Share: