Activity
 
Notifications
Clear all
xenon
xenon
Group: Registered
Joined: 2021/06/09
Eminent Member
2
maybe the temp is off. higher temperatures lead to more stri...

In forum Assembly and first prints troubleshooting

1 month ago
both have wires. the heater cartridge does the heating and h...

In forum Hardware, firmware and software help

1 month ago
live z has absolutely nothing to with the described problem....

In forum Assembly and first prints troubleshooting

1 month ago
no need to change them. they start heating with the M104/M14...

In forum Hardware, firmware and software help

2 months ago
i bit the bullet and bought a flashair card. no regrets th...

In forum General discussion, announcements and releases

2 months ago
yep, that looks way too high. you might want to look at the ...

In forum Assembly and first prints troubleshooting

3 months ago
maybe thats why they dont suggest lubricating the bearings d...

In forum Hardware, firmware and software help

3 months ago
x rods inserted correctly, or are they putting pressure on t...

In forum Assembly and first prints troubleshooting

3 months ago
getting this integrated into stock prusaslicer and firmware ...

In forum General discussion, announcements and releases

3 months ago
that sounds strange. your thermometer does go higher than 17...

In forum Assembly and first prints troubleshooting

3 months ago
just paint half the end face of the shaft of the extruder st...

In forum Assembly and first prints troubleshooting

3 months ago
sounds good. hopefully you got your z offset dialed in now, ...

In forum Assembly and first prints troubleshooting

3 months ago
for prusament petg i had to crank it up to 1,077 to get the ...

In forum Assembly and first prints troubleshooting

3 months ago
extrusion multiplier (or flow) should be looked at with each...

In forum Assembly and first prints troubleshooting

3 months ago
maybe leave both parameters at their standard values and adj...

In forum General discussion, announcements and releases

3 months ago
for smoother surface of the silicone cast piece, you can coa...

In forum General discussion, announcements and releases

3 months ago
sure, it loks good for the first part. but if the gcode was ...

In forum Assembly and first prints troubleshooting

3 months ago
check the assembly pictures. the hotend cooling fan cannot b...

In forum Hardware, firmware and software help

3 months ago
move the horizontal slider to see exactly how the layer is p...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 months ago
infill/perimeter overlap is also a major factor for this bui...

In forum Assembly and first prints troubleshooting

3 months ago
Page 1 / 2
Share: