Notifications
Clear all
BogdanH
BogdanH
Group: Registered
Joined: 2021/05/26
Reputable Member
5
First, you need to have pretty much clear idea about design ...

In forum How do I print this? (Printing help)

1 hour ago
You can't "simulate" thermistor being connected by jumping t...

In forum General discussion, announcements and releases

2 hours ago
This might help.

In forum General discussion, announcements and releases

2 hours ago
Are both Mini's new? If not, how old? The one that makes bad...

In forum General discussion, announcements and releases

2 hours ago
-you're right. It's hard to say without having actual file.....

In forum How do I print this? (Printing help)

1 day ago
After heatsink is assembled into housing, it's impossible to...

In forum Assembly and first prints troubleshooting

1 day ago
Open the extruder and check if gear on motor shaft is not lo...

In forum Assembly and first prints troubleshooting

1 day ago
Seems you checked usual suspects, so what's left... Make "fa...

In forum Assembly and first prints troubleshooting

2 days ago
Simple (non heated) tent-box wont work in garage. As far I k...

In forum General discussion, announcements and releases

2 days ago
When printing, surrounding temperature should be at least 65...

In forum General discussion, announcements and releases

2 days ago
@sanrebYour first layer shows that nozzle is way too high -y...

In forum Assembly and first prints troubleshooting

2 days ago
If you only print PLA, at least so far, then clogs indicate ...

In forum Hardware, firmware and software help

2 days ago
As bobstro mentioned, reading trough "PS knowledge base" is ...

In forum General discussion, announcements and releases

2 days ago
The example on photo is exactly 0.2mm thick.

In forum General discussion, announcements and releases

2 days ago
Very interesting -compliments! Thank you for sharing 😀

In forum How do I print this? (Printing help)

2 days ago
That small rectangle that we get at the end of first layer c...

In forum General discussion, announcements and releases

2 days ago
Probably not (as seen on photo). Just put it back in and obs...

In forum Hardware, firmware and software help

3 days ago
Hear, hear.. 😍 First, I'm glad you made it. I see you're re...

In forum Assembly and first prints troubleshooting

3 days ago
Why don't you check if that's the case? -it's something only...

In forum Hardware, firmware and software help

4 days ago
First layer should be close to 0.2mm

In forum Assembly and first prints troubleshooting

4 days ago
Page 1 / 13
Share: