Activity
 
Notifications
Clear all
Brad
Brad
Group: Registered
Joined: 2021/05/15
Trusted Member
3
If you have not already done so then I would recommend perfo...

In forum Hardware, firmware and software help

4 weeks ago
Yes I installed the Delta P fan duct and after a while concl...

In forum Hardware, firmware and software help

4 weeks ago
This is the one that I tried on my Mk3S+:

In forum Hardware, firmware and software help

4 weeks ago
I did print and switch to the above mentioned improved part ...

In forum Hardware, firmware and software help

4 weeks ago
Post link

In forum Hardware, firmware and software help

1 month ago
Are you sure that it is not silver? If it is then it could b...

In forum Hardware, firmware and software help

1 month ago
Very hot water from the tap usually runs/slides straight off...

In forum Hardware, firmware and software help

1 month ago
Have you tried belt test on the calibration menu? This will ...

In forum Hardware, firmware and software help

1 month ago
I've had something similar on a different printer when my me...

In forum General discussion, announcements and releases

1 month ago
I agree with @diem that that PETG filament still looks damp....

In forum How do I print this? (Printing help)

1 month ago
I am not sure what my calibration cubes would look like if t...

In forum Assembly and first prints troubleshooting

1 month ago
All glowing reports! Thank you. I will definitely treat myse...

In forum General discussion, announcements and releases

2 months ago
I really like the textured sheet for PETG and will continue ...

In forum General discussion, announcements and releases

2 months ago
And it would not help that the default Cura profile for the ...

In forum Assembly and first prints troubleshooting

2 months ago
Not necessarily an answer to your concern but I thought that...

In forum Assembly and first prints troubleshooting

2 months ago
Having seen your video - I am sure that this is my problem t...

In forum How do I print this? (Printing help)

2 months ago
It is worth noting the final comment in the comments section...

In forum Hardware, firmware and software help

2 months ago
You could run the scan a couple more times and if the front ...

In forum How do I print this? (Printing help)

2 months ago
I never managed to get PLA to stick to my textured sheet pro...

In forum Assembly and first prints troubleshooting

2 months ago
Must be nice to have a whole farm at your disposal for hobby...

In forum General discussion, announcements and releases

2 months ago
Page 1 / 3
Share: