Activity
 
Notifications
Clear all
BrettG
BrettG
Group: Registered
Joined: 2021/05/13
Trusted Member
3
Been using the llama firmware on one of my mini’s as a trail...

In forum Hardware, firmware and software help

4 weeks ago
Great to hear , I’ve ordered from them . thank you both . Gr...

In forum Hardware, firmware and software help

4 weeks ago
Thanks for the info , will have a look into that seller the...

In forum Hardware, firmware and software help

4 weeks ago
Buddy board replacement

In forum Hardware, firmware and software help

4 weeks ago
Very true Karl , we use what we have available 🙂 , Having ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
ended up opening up the thru hole using a Endmill at work on...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
Has anyone else experienced the incorrect amount when purcha...

In forum User mods - OctoPrint, enclosures, nozzles, ...

1 month ago
great thread with some helpful information when it comes to ...

In forum General discussion, announcements and releases

2 months ago
Been through it with prusa support and they also confirmed i...

In forum Hardware, firmware and software help

2 months ago
So I tested the fan on another mini and it worked fine . r...

In forum Hardware, firmware and software help

2 months ago
Ye I think you're right, to be honest if they don't work and...

In forum Hardware, firmware and software help

2 months ago
I also get this issue on one of my mini's in the higher part...

In forum Hardware, firmware and software help

2 months ago
these are what I went for, will double check these in anothe...

In forum Hardware, firmware and software help

2 months ago
Thanks for the links but I'm in the uk

In forum Hardware, firmware and software help

2 months ago
Printer fan not working

In forum Hardware, firmware and software help

2 months ago
Bed Thermistor Alternative ?

In forum Hardware, firmware and software help

2 months ago
Good advice, I had the same issue and when you wobble the Y ...

In forum Hardware, firmware and software help

2 months ago
Messed around creating a extruder based on bernies but could...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Ok thanks looks like I’m going to for the triangle then , ye...

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Thanks for that cwbullet

In forum User mods - OctoPrint, enclosures, nozzles, ...

2 months ago
Page 1 / 4
Share: