Notifications
Clear all
vanayad
vanayad
Group: Registered
Joined: 2021/05/12
Eminent Member
2
For that volume, I'd need a 0.6 nozzle and a 370mm infill sp...

In forum Hardware, firmware and software help

3 months ago
It was a reduction of about 40h in time overall (from 100 ho...

In forum Hardware, firmware and software help

3 months ago
I think it can do more than 45mm3/s, I've been told to simpl...

In forum Hardware, firmware and software help

3 months ago
Indeed, the slow down if layer print time is below X was the...

In forum Hardware, firmware and software help

3 months ago
Increasing printing speeds doesn't lower printing time

In forum Hardware, firmware and software help

3 months ago
Hi, even after unclogging the dragon (coldpulls + material e...

In forum Hardware, firmware and software help

4 months ago
I remove the clog, extrude some material to make sure it is ...

In forum Hardware, firmware and software help

4 months ago
Anyone got any ideas on how to fix the clogging? 🙁 I've tri...

In forum Hardware, firmware and software help

4 months ago
so you're printing with a dragon high flow with a 0.4 nozzle...

In forum Hardware, firmware and software help

4 months ago
Nope, it is open... 🙁

In forum Hardware, firmware and software help

4 months ago
I'm printing this:/p>

In forum Hardware, firmware and software help

4 months ago
I cannot print it, the 0.4 nozzle gets clogged before finish...

In forum Hardware, firmware and software help

4 months ago
Could it be that it is a high flow hot end and I'm using a 0...

In forum Hardware, firmware and software help

4 months ago
I have not, but I will. I doubt it is a filament issue, I'm ...

In forum Hardware, firmware and software help

4 months ago
I changed the nozzle and printed another benchy. Same result...

In forum Hardware, firmware and software help

4 months ago
I was wondering if the issue could be the nozzle? I'm using ...

In forum Hardware, firmware and software help

4 months ago
Do note that it was really hard to get the filament flowing....

In forum Hardware, firmware and software help

4 months ago
Several. It comes out clean.

In forum Hardware, firmware and software help

4 months ago
Dragon Hotend Mod keeps...clogging? I don't know exactly. St...

In forum Hardware, firmware and software help

4 months ago
Extruder prints for a few minutes then grinds some filament....

In forum Assembly and first prints troubleshooting

5 months ago
Page 1 / 2
Share: