Notifications
Clear all
themzlab
themzlab
Group: Registered
Joined: 2017/07/30
Estimable Member
4
Ordered end of september 2018, still waiting. Ordered a pr...

In forum General discussion, announcements and releases

3 years ago
if It is just an invite, you can ignore the invitation and n...

In forum General discussion, announcements and releases

3 years ago
hi tiago.c, I do agree with you, the springs you found are ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
hi tiago.c, I do agree with you, the springs you found are ...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
I wonder why this works better than mesh bed leveling? It's...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
in some very limited scenario, perhaps. On the other hand, ...

In forum General discussion, announcements and releases

3 years ago
it's fine. I do this occasionally. The sound will be di...

In forum General discussion, announcements and releases

3 years ago
Hi William, as I understand the situation, you currently ha...

In forum Assembly and first prints troubleshooting

3 years ago
.... Have you seen defects that you can identify with either...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
Just looking at the front on view, it looks like when you ad...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
If you are tearing the print, you need to raise (make less n...

In forum Assembly and first prints troubleshooting

3 years ago
With live Z at -1.50 it indicates the Pinda sensor is not at...

In forum Assembly and first prints troubleshooting

3 years ago
Lower the live Z a little bit. It should be a negative numb...

In forum Assembly and first prints troubleshooting

3 years ago
spreading distance between X axis rods for more rigid extrud...

In forum User mods - OctoPrint, enclosures, nozzles, ...

3 years ago
First make sure this is repeatable - do you get the same aff...

In forum General discussion, announcements and releases

3 years ago
one thought - reach under the bed and see if you can wiggle ...

In forum Hardware, firmware and software help

3 years ago
one more example - this is the R3 part from Prusa - "nozzle-...

In forum Awesome prints (Hall Of Fame)

3 years ago
actual part: black Polymaker PC-Max which claims to have tem...

In forum Awesome prints (Hall Of Fame)

3 years ago
Page 1 / 7
Share: