Notifications
Clear all
Dai Wee Mike
Dai Wee Mike
Group: Registered
Joined: 2021/05/10
Eminent Member
2
I’m thinking 6 months is a nice round figure so will start o...

In forum General discussion, announcements and releases

3 weeks ago
For me will be to recognize when the print quality is droppi...

In forum General discussion, announcements and releases

4 weeks ago
Thank you sir. Valuable info from the front line. I will ord...

In forum General discussion, announcements and releases

4 weeks ago
When should i replace nozzle?

In forum General discussion, announcements and releases

4 weeks ago
Where do i get this file? Thanks. Semi noob still.

In forum How do I print this? (Printing help)

2 months ago
What is this unsightly mess?

In forum How do I print this? (Printing help)

2 months ago
Words fail me. This is so next level I cant even relate prop...

In forum Awesome prints (Hall Of Fame)

2 months ago
What aircraft are you printing? I am just finishing up an Ec...

In forum How do I print this? (Printing help)

2 months ago
Oh well…

In forum Hardware, firmware and software help

2 months ago
😝 Had a feeling this would be the consensus... thank for the...

In forum General discussion, announcements and releases

3 months ago
Is this bad behaviour or just fun?

In forum General discussion, announcements and releases

3 months ago
Ha - I think I solved my own question ... just going to prin...

In forum General discussion, announcements and releases

3 months ago
@cwbullet Thanks for that. I'm printing a pair of winglets a...

In forum General discussion, announcements and releases

3 months ago
@cwbullet Thanks for that. I'm printing a pair of winglets a...

In forum General discussion, announcements and releases

3 months ago
Anyone printed LW PLA?

In forum General discussion, announcements and releases

3 months ago
Guys I’m grateful for all your feedback. Really. This is ope...

In forum General discussion, announcements and releases

4 months ago
@baklin I will feed the kids and then start watching the vid...

In forum General discussion, announcements and releases

4 months ago
OK great stuff guys. I just DL'd Fusion 360 and I can see t...

In forum General discussion, announcements and releases

4 months ago
OK thanks a lot. So it should be within my limited capabilit...

In forum General discussion, announcements and releases

4 months ago
How do I edit an existing .stl file?

In forum General discussion, announcements and releases

4 months ago
Page 1 / 2
Share: