Notifications
Clear all
John Doe
John Doe
Group: Registered
Joined: 2021/05/04
Active Member
1
Dan Rogers, you were right again. Even though I repositione...

In forum Assembly and first prints troubleshooting

4 months ago
Z Axis crash

In forum Assembly and first prints troubleshooting

4 months ago
Thank you, this did seem to solve the problem... for the X a...

In forum Assembly and first prints troubleshooting

4 months ago
X Axis failure

In forum Assembly and first prints troubleshooting

5 months ago
Ah! We already suspected that but it's nice to know the mach...

In forum Hardware, firmware and software help

5 months ago
Still trying to figure out this multimeter I bought. There ...

In forum Hardware, firmware and software help

5 months ago
Thank you for this response. I haven't done any of this yet...

In forum Hardware, firmware and software help

5 months ago
I'm not sure how to answer that, it used to heat up to 210 o...

In forum Hardware, firmware and software help

5 months ago
Nozzle won't heat up past 25 Celsius

In forum Hardware, firmware and software help

5 months ago
I'm fairly new with all this but I had a similar problem abo...

In forum Hardware, firmware and software help

5 months ago
@dan-rogers Yeah, the control panel has nothing going to it....

In forum Hardware, firmware and software help

7 months ago
I've rechecked the cords a third time. It would seem despit...

In forum Hardware, firmware and software help

7 months ago
So red is the color of a working board? I just built my Pru...

In forum Assembly and first prints troubleshooting

7 months ago
RE: Partial Power after assembled

In forum Hardware, firmware and software help

7 months ago
Partial Power after assembled

In forum Hardware, firmware and software help

7 months ago
Share: