Notifications
Clear all
Lensdigital
Lensdigital
Group: Registered
Joined: 2017/07/26
Active Member
1
That completely defies the purpose of quick convenience of e...

In forum General discussion, announcements and releases

2 years ago
Yeah good point. I usually heat up my nozzle from OctoPrint ...

In forum General discussion, announcements and releases

2 years ago
Why preheat bed to unload filament?

In forum General discussion, announcements and releases

2 years ago
I think you guys forgot to include English version of firmwa...

In forum General discussion, announcements and releases

3 years ago
After running PID tune, problem went away...

In forum Hardware, firmware and software help

3 years ago
Hotened temperature lagging by 10 C

In forum Hardware, firmware and software help

3 years ago
Sorry guys I didn't see replies, notification got turned off...

In forum Print tips (Archive)

3 years ago
Thanks a lot for the advise! I just got replacement bearings...

In forum Others (Archive)

4 years ago
Smooth rods wearing out...

In forum Others (Archive)

4 years ago
Armadillo filament settings and print results

In forum Print tips (Archive)

4 years ago
All good now. I figured out different approach, a safer meth...

In forum Prusa i3 kit (Archive)

4 years ago
Thanks a lot Aaron! Wish paper part was mentioned in the ...

In forum Prusa i3 kit (Archive)

4 years ago
Calibration destroyed part of my heat bed 🙁

In forum Prusa i3 kit (Archive)

4 years ago
Thanks Joan! Indeed this is a nice surprise 🙂 Gonna have t...

In forum Others (Archive)

4 years ago
How did 7 weeks wait turned into 7 days?

In forum Others (Archive)

4 years ago
Share: