Notifications
Clear all
takedownca
takedownca
Group: Registered
Joined: 2017/06/22
Active Member
1
Finally getting around to upgrading my MK3 to a MK3S, and af...

In forum General discussion, announcements and releases

5 months ago
Multiple Upgrades

In forum Assembly and first prints troubleshooting

2 years ago
Machine isn't bricked, but it's owner is. Turns out that las...

In forum Hardware, firmware and software help

2 years ago
No worries. You'd think after several millennia of experienc...

In forum Hardware, firmware and software help

2 years ago
Tim, as I said, I'll be redownloading the file just in case....

In forum Hardware, firmware and software help

2 years ago
I appreciate all the spirited conversation around my lowly f...

In forum Hardware, firmware and software help

2 years ago
Well, that's unfortunate :/ I can do a bit of soldering, but...

In forum Hardware, firmware and software help

2 years ago
Firmware Flash Fails

In forum Hardware, firmware and software help

2 years ago
It's 1:40AM here, so I'll try a heat gun tomorrow. If I'm lu...

In forum Others (Archive)

3 years ago
Did you try to undo them hot or cold? When ever doing any ...

In forum Others (Archive)

3 years ago
Did I mention the button head screw holding the heating elem...

In forum Others (Archive)

3 years ago
Tried to remove the busted thermistor, but the set screw hol...

In forum Others (Archive)

3 years ago
Found it 🙂

In forum Others (Archive)

3 years ago
Thanks. Looks like the Prusa Shop isn't selling them to US b...

In forum Others (Archive)

3 years ago
Thanks. Once I replace my busted thermistor I'll give your s...

In forum Others (Archive)

3 years ago
Print Head Salvagable?

In forum Others (Archive)

3 years ago
First build - nozzle keeps catching

In forum Others (Archive)

3 years ago
Share: